2008 Honda Cr-v Ex All Wheel Drive Sunroof Cloth Seats Abs 24700 Miles Low Miles on 2040-cars
Wayne, New Jersey, United States
Vehicle Title:Clear
For Sale By:Dealer
Engine:2.4L 2354CC l4 GAS DOHC Naturally Aspirated
Body Type:Sport Utility
Fuel Type:GAS
Make: Honda
Model: CR-V
Trim: EX Sport Utility 4-Door
Transmission Description: AUTOMATIC
Number of Doors: 4
Drive Type: 4WD
Drivetrain: 4 Wheel Drive
Mileage: 24,700
Sub Model: EX
Number of Cylinders: 4
Exterior Color: Tan
Interior Color: Tan
Honda CR-V for Sale
- Ex (4x4) suv 2.4l cd traction control stability control tires - front all-season(US $15,688.00)
- 2010 honda cr-v ex-l sport utility 4-door 2.4l(US $13,999.00)
- 2010 honda cr-v ex-l - rebuildable salvage title ***no reserve***
- 2010 honda cr-v ex-l 2.4l 4 cylinder 4x4 sunroof heated leather seats 39k video(US $20,500.00)
- 2001 honda crv se fully loaded leather sport utility 4wd vehicle auto automobile(US $4,799.00)
- Must see honda crv * heated seats * sunroof * new rear brakes * super clean car
Auto Services in New Jersey
Woodbridge Transmissions ★★★★★
Werbany Tire And Auto Repair ★★★★★
Vonkattengell Transmission Service ★★★★★
True Racks Ltd ★★★★★
Top Dude Tint ★★★★★
TM & T Tire ★★★★★
Auto blog
NHTSA probing 400,000 Infiniti, Honda vehicles over steering faults
Tue, 11 Nov 2014As many as 391,000 vehicles from Infiniti and Honda may eventually need to be recalled as a result of two, separately announced Preliminary Evaluations from the National Highway Traffic Safety Administration to ascertain the scope of the potential safety hazards.
The larger investigation has NHTSA looking into the 2013 Honda Accord because of 24 reports from drivers alleging total loss of power steering or a sudden increase in necessary effort to turn the vehicle. In four cases, the problem is reportedly linked to crashes, with all of them occurring at less than 30 miles per hour. According to the claims, 13 people also reported seeing a warning message during the failure. Turning off the car and restarting it would fix the issue in some cases. If a recall is necessary, it could affect an estimated 374,000 Accords.
The second investigation is much smaller in scope. The safety agency is investigating the 2008 Infiniti EX35 after two complaints of the steering wheel shaft separating, and the vehicle losing the ability to steer. Both reports allege that the steering became loose when driving and then completely failed once the vehicle was stopped. A recall for the problem would affect an estimated 17,000 vehicles. Scroll down to read NHTSA's reports on both Preliminary Evaluations.
Acura NSX production delayed
Fri, Aug 14 2015Listeners of the Autoblog Podcast will be familiar with my opinions on the Acura NSX. While I love the idea of Acura building a halo car again, I've routinely joked on-air that the car will never, ever reach production and will continue being teased and previewed ad nauseam. So I'm chuckling at this news: the NSX is being delayed again. To be fair, while it sounds like a big deal – pushing the NSX back from model year 2016 to 2017 – this is a fairly minor delay in the grand scheme. Instead of starting production this fall, as previously announced, the new supercar will start rolling down the line at Honda's Marysville, OH factory in the spring. "Trial production" has already started, Honda says, while briefly acknowledging the delay in the attached press release. While Honda offered no reason for the delay in volume production, Automobile claims it's the fault of the move to fit two turbochargers to the V6, which was made midway through development. Fitting the two iron lungs meant rearranging the six-pot into a longitudinal layout. Here's hoping there are no further delays. Scroll on for a look at Honda's press release, which does its best to gloss over the NSX delay while talking about the company's new Performance Manufacturing Center in Marysville. Related Video: Performance Manufacturing Center: Precision Craftsmanship Aug 14, 2015 - CARMEL-BY-THE-SEA, Calif. The next-generation Acura NSX is produced at the new, dedicated Performance Manufacturing Center (PMC) in Marysville, Ohio, using domestic and globally sourced parts. With trial production already underway and production start-up scheduled for spring 2016, this world-class manufacturing facility employs groundbreaking techniques in weld, body construction, body painting, final assembly and quality confirmation to ensure the highest levels of precision and craftsmanship. More details on the unique and innovative manufacturing processes at the PMC will be rolled out over the months leading up to the start of production, but the following highlights of the new facility were shared during the 2015 Monterey Automotive Week: Innovative blend of people and technology: throughout the PMC, NSX production is centered around the skills of approximately 100 experienced engineers and technicians building the NSX to precise levels of quality and craftsmanship.
Honda Civic Type R on track to smash 'Ring record, eclipse NSX
Wed, 01 Oct 2014Honda has made some serious performance machinery over the course of its history, but few products have been as hotly anticipated as the upcoming new Civic Type R. Following a deep and proud history of Type R Hondas, the latest Japanese hot hatch is continuing its long striptease at the Paris Motor Show this week. But before it does, Honda has released this video clip featuring project leader Suehiro Hasshi - and he has some bold claims to make.
For one, he says it'll be the best Type R yet - and that's quite a statement considering some of its predecessors, including the almighty NSX Type R. Hasshi-san also reiterates Honda's aim of snatching the front-drive lap record at the Nürburgring away from the likes of Renault and Seat, and reports that the Honda team is on track to chew every bit it's biting off. In short, the new Civic Type R ought to be sensational.