2008 Gmc Yukon Xl Slt 4x4, 5.3l, Heated Lthr, Tow Pkg, Carfax Cert, Serviced!!! on 2040-cars

Auto blog

GMC Sierra Denali CarbonPro bed is finally, almost here

GMC revealed the Sierra 1500 with the optional CarbonPro bed on March 1, 2018. The bed wasn't available at launch, though. You can't buy it now, either, but it will hit dealerships with limited availability after production starts in early June, exclusively for the Denali 1500 and AT4 1500 trims. The carbon floor and sides replace the steel panels in a normal bed, providing "strength, durability, and scratch resistance" and a potential 59-pound weight saving, depending on the truck's configuration. To make sure the bed had a chance, development engineers replicated "extreme use scenarios" like dropping 1,800-pound gravel loads, 450-pound steel drums, and cinder blocks from various heights. They put a 250-pound man on a snowmobile with studded tracks, had him drive into the bed and then go wide-open throttle. We're told the result was "minimal scratching." On top of the extreme weather testing any vehicle goes through, the team also put a generator in the bed and aim the exhaust into a corner to ensure vibration and direct heat wouldn't deform the carbon fiber. Because of the finer shaping area-specific strength possible with carbon fiber, the bed provides one cubic foot of additional payload space by having its sidewalls pushed further out. The CarbonPro bed doesn't need a bedliner, and is grained at the top for better traction but smooth on the bottom for easier hosing down and dirt removal. Tie-downs at the front of the bed work with molded indentations to hold motorcycle tires, and slots in the sidewalls hold two-by-sixes. The truck maker says the carbon-lined payload area confers "best-in-class dent, scratch and corrosion resistance," but we suppose the nation's pickup truck army will prove that or not. The trucks likely won't have the hardest life at the start, since the Sierra Denali costs $56,790 before even a basic option like four-wheel drive. The real test probably won't come until around 2029, when third owners begin treating their aerospace-inspired thoroughbreds like dray horses.

NHTSA upgrades probe into 1.7 million GM vehicles over wiper failures

WASHINGTON — The U.S. National Highway Traffic Safety Administration (NHTSA) said Tuesday it is upgrading an investigation into 1.7 million General Motors vehicles for windshield wiper failures. The auto safety agency opened the probe in November 2018 to see if GM needed to expand a 2016 recall of 2013 model year Chevrolet Equinox and GMC Terrain SUVs to cover additional vehicles. The engineering analysis probe covers 2010-2012 and 2014-2016 Equinox and Terrain vehicles. NHTSA could demand a recall after it completes the probe. NHTSA said it has reviewed 1,900 complaints and reports related to the issue in the 1.7 million vehicles. NHTSA said it has seen elevated failure rates in the 1.7 million vehicles, even though GM said the recalled vehicles have "double the warranty rate and five times the complaint rate." GM said it will "fully cooperate to support their investigation. We do not believe these windshield washer systems are defective." The wiper failures that prompted the 2016 recall were attributed to water and debris intrusion into the windshield wiper assembly ball joints, leading to excessive wear and eventual detachment of the ball joint. GM said it was installing an improved windshield wiper motor and transmission assembly and relocating a drain hole at the base of the windshield. Related Video:

GM readying aluminum-body fullsize pickups

Ford's extensive use of aluminum in its 2015 F-150 is a big deal. A really big deal. Big enough, in fact, that General Motors is reportedly changing its fullsize pickup strategy. According to The Wall Street Journal, The General has locked in partnerships with Alcoa Inc. and Novelis Inc. - companies that will supply aluminum for the next-generation Chevrolet Silverado and GMC Sierra trucks.
"Ford's introduction of the 2015 F-150 pickup truck was a game changer, and it's the first, not the last, conversion of this type," Novelis spokesperson Charles Belbin told the Journal. The switch to aluminum has allowed Ford to shave roughly 700 pounds off its fullsize truck's curb weight. And while official mileage ratings have not been announced, the weight loss should go a long way for improving efficiency, especially when combined other efficiency-minded improvements including better aerodynamics and new, turbocharged V6 engines.
Of course, aluminum-bodied cars are nothing new. But extensive use of aluminum in a major, best-selling product like the Ford F-150 is expected to kick off widespread use of this weight-saving material as availability rises and cost decreases. The WSJ reports that GM had originally explored the idea of moving to aluminum pickups back in 2008, but abandoned the idea due to cost concerns amid economic woes.