2009 Gmc Yukon Denali Sport Utility Awd 100k Mile Factory Warranty Immaculate on 2040-cars

Auto blog

NHTSA closes 4-year GM investigation, issues common sense advisory [w/video]

Since January 2011, the National Highway Traffic Safety Administration has been investigating a possible problem with corroding brake lines in General Motors' GMT800-platform models, like the Chevrolet Silverado and Suburban and GMC Sierra, in states with salt on their roads in the winter. However, as opposed to launching a full recall of millions of vehicles, the government is issuing a common-sense safety advisory to all drivers in snowy states to keep their vehicle's undercarriage clean. It even has a video explaining things. "Older-model vehicles, often driven in harsh conditions, are subject to corrosion over long periods of time, and we need owners to be vigilant about ensuring they, their passengers, and others on the roads are safe," said NHTSA Administrator Mark Rosekind in the announcement of the end of the investigation. The agency was clear in its report that "brake line corrosion seen in the GM vehicles was not unique," and the government "has not identified a defect that would initiate a recall order." Instead NHTSA is advising drivers, especially those of vehicles from before 2007, to wash their vehicle's undercarriage in the winter and spring to remove salt or other de-icing chemicals. It also recommends regular checks by a mechanic to make sure everything is in proper order. According to the investigation documents, for just the GMT800 platform models, NHTSA found 3,645 complaints of brake line corrosion, which included allegations of 107 crashes and 40 injuries. The issue was found to be more common in vehicles over 10 years old. GM has released a statement (embedded below) that the company "supports the consumer advisory from NHTSA urging regular maintenance and care of brake lines on older vehicles." NHTSA Closes Investigation into Brake-Line Failures NHTSA 13-15 Thursday, April 9, 2015 Agency issues safety advisory on preventing undercarriage corrosion WASHINGTON – The Department of Transportation's National Highway Traffic Safety Administration (NHTSA) today issued a Safety Advisory and consumer video encouraging owners of model year 2007 and older trucks, SUVs and passenger cars to inspect brake lines and thoroughly wash the underside of their vehicles to remove corrosive salt after the long winter in order to prevent brake-line failures that increase the risk of a crash.

GMC Syclone spools up a storm on Jay Leno's Garage

A storm was brewing on American roads in the early 1990s. That's when Detroit's automakers were producing some of the hottest performance trucks ever devised – models like the Ford Lightning, GMC Typhoon, and its flyweight pickup sibling, the GMC Syclone. Jay Leno just happens to have one of the latter in his garage, and took it out to showcase in this latest video segment. The Syclone was an exercise in absurdity, and could not only trounce any other pickup on the road, it could outrun anything else GM made and just about anything else on the road – beating Ferraris and Porsches off the line. In a pickup, for crying out loud. The kicker is that its engine wasn't such a monster, either: under the hood sat a 4.3-liter turbocharged V6 pumping out what would seem by today's standards to be an adequate 280 horsepower and 350 pound-feet of torque. Even the smaller of the EcoBoost V6s available in today's Ford F-150 produces more than that. But in a lightweight, compact pickup, those figures were enough to propel the Syclone to 60 in 4.3 seconds and run the quarter-mile in 13.6 seconds. Long before the dune-jumping Ford F-150 SVT Raptor or even the Viper-powered Dodge Ram SRT-10, GM made fewer than 3,000 Syclones based on the compact Sonoma (sister to the Chevy S-10) and another 4,700 of the Typhoon, which was mechanically similar but more practical (albeit heavier) wagon bodywork from the Jimmy. But as Jay aptly points out, the Syclone was the one you wanted. Scope it out in the ten-minute video clip above.

GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]

UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.