2004 Gmc Yukon Denali Xl on 2040-cars

Auto blog

IIHS: High numbers of drivers treat partially automated cars as fully self-driving

WASHINGTON — Drivers using advanced driver assistance systems like Tesla Autopilot or General Motors Super Cruise often treat their vehicles as fully self-driving despite warnings, a new study has found. The Insurance Institute for Highway Safety (IIHS), an industry funded group that prods automakers to make safer vehicles, said on Tuesday a survey found regular users of Super Cruise, Nissan/Infiniti ProPILOT Assist and Tesla Autopilot "said they were more likely to perform non-driving-related activities like eating or texting while using their partial automation systems than while driving unassisted." The IIHS study of 600 active users found 53% of Super Cruise, 42% of Autopilot and 12% of ProPILOT Assist owners "said that they were comfortable treating their vehicles as fully self-driving." About 40% of users of Autopilot and Super Cruise — two systems with lockout features for failing to pay attention — reported systems had at some point switched off while they were driving and would not reactivate. "The big-picture message here is that the early adopters of these systems still have a poor understanding of the technologyÂ’s limits," said IIHS President David Harkey. The study comes as the National Highway Traffic Safety Administration (NHTSA) is scrutinizing Autopilot crashes. Since 2016, the NHTSA has opened 37 special investigations involving 18 deaths in crashes involving Tesla vehicles and where systems like Autopilot were suspected of use. Tesla did not respond to requests for comment. Tesla says Autopilot does not make vehicles autonomous and is intended for use with a fully attentive driver who is prepared to take over. GM, which in August said owners could use Super Cruise on 400,000 miles (643,740 km) of North American roads and plans to offer Super Cruise on 22 models by the end of 2023, did not immediately comment. IIHS said advertisements for Super Cruise focus on hands-free capabilities while Autopilot evokes the name used in passenger airplanes and "implies TeslaÂ’s system is more capable than it really is." IIHS in contrast noted ProPILOT Assist "suggests that itÂ’s an assistance feature, rather than a replacement for the driver." NHTSA and automakers say none of the systems make vehicles autonomous. Nissan said its name "is clearly communicating ProPILOT Assist as a system to aid the driver, and it requires hands-on operation.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

2014 Chevrolet Silverado and GMC Sierra debut all-new designs, three new engines

General Motors has finally dropped the curtain on the 2014 Chevrolet Silverado and 2014 GMC Sierra. Both trucks have undergone substantial revisions with updated versions of the company's 4.3-liter V6, 5.3-liter V8 and 6.2-liter V8 engines. In a shot across the bows of both Ford and Chrysler, GM says it won't use a V6 engine adapted from passenger car applications. Instead, it developed the 4.3-liter engine based on its proven truck-duty architecture.
All three mills will boast direct injection fuel systems as well as a new cylinder head design. Combined with a revised piston, the new engines feature a smaller combustion chamber with a compression ratio of 11:1 or higher depending on the application. Cylinder deactivation and continuously variable valve timing are all part of the recipe, and each engine is paired with a six-speed automatic transmission with auto grade breaking. So far, no fuel economy or horsepower figures have been released, though GM says the new engines will best their predecessors in both areas.
Outside, the trucks feature a number of enhancements to reduce drag and wind noise, and GM claims both the Silverado and Sierra will offer buyers some of the quietest cabins in the class. Extended cab models now feature front-hinged rear doors to allow easier access to the back passenger area, and Crew Cab buyers can now select between a five-foot, eight-inch bed or a six-foot, six-inch bed. Buyers with a mind toward going off road will also rejoice in the return of the Z71 package, complete with Rancho shocks, front tow hooks and additional under-body protection.