** C10 ** Patina ** Shop Truck ** Carry All ** on 2040-cars

Auto blog

GM diesel pickups first to undergo extra EPA, CARB testing

The effects of Volkswagen's long-running diesel emissions evasion are starting to spill over to other automakers, but General Motors is taking things in stride. The 2.8-liter, four-cylinder Duramax in the 2016 Chevrolet Colorado and GMC Canyon is the first engine to get extra scrutiny by the Environmental Protection Agency and the California Air Resources Board, Automotive News reports. Rather than just the usual in-lab test, it's also being checked on the road. However, the extra evaluation shouldn't have any impact on when the trucks with his mill hit dealers later this fall. "We're in our final stages of the EPA certification, and our launch is on track," Chevy spokesperson Otie McKinley tells Autoblog. The four-cylinder diesel in the trucks makes 181 horsepower and 369 pound-feet of torque, and the automaker is touting low NOx production. In the announcement for the Colorado's specs, the company calls it "the cleanest diesel truck engine ever produced by General Motors." The tech includes exhaust gas recirculation to lower combustion temperatures and improve emissions. There's also a urea tank like on the bigger diesels for full-size trucks, and it gets refilled in time with oil changes. An indication on the instrument panel lets drivers know when that's needed, too. Even with the more demanding testing, the company doesn't seem too worried about the four-cylinder passing. "Part of our development process is on-road and off-road [laboratory] testing," Scott Yackley, Chevy Trucks assistant chief engineer, said to Automotive News. In the wake of the VW scandal, the EPA has pledged more rigorous testing. Before, on-road emissions evaluations were largely limited to heavy-duty vehicles, but the agency has decided to apply the checks more often to other models. There's also now greater cooperation with Canadian authorities.

2014 GMC Sierra 4.3L V6 to offer segment-best 305 LB-FT

General Motors has released more information on the 4.3-liter V6 available in the 2014 GMC Sierra. The engine will serve up 285 horsepower and 305 pound-feet of torque, with a six-speed automatic transmission, and giving the V6 Sierra a maximum tow rating of 7,200 pounds in regular cab, short bed four-wheel drive configuration. GM claims that figure is 500 pounds more than the equivalent Ford F-150 equipped with a 3.7-liter V6, and 700 pounds more than the Ram 1500 with its 3.6-liter V6. Buyers can expect to see the 2014 GMC Sierra with the 4.3-liter engine start at $25,085 including destination.
While the engine does deliver more torque than either of its main competitors, it falls short on the horsepower front. The 3.7-liter V6 in the F-150 develops 302 hp while the 3.6-liter V6 in the Ram 1500 yields 305 hp. GM says fuel economy estimates for its newest entry will land later this year. Check out the full press release below for more information.

2015 GMC Canyon

As discussed earlier today, the 2015 Chevrolet Colorado is a new standout in terms of midsize trucks. But the Colorado wasn't the only pickup the General Motors team brought to San Diego for us to sample. Also along for the ride was a pack of GMC Canyons, the slightly more expensive and polished platform-mate to the Chevy.
There's no question that the Canyon and the Colorado are a lot alike under the skin - almost entirely, in fact - so GMC has worked to first create some daylight between the two trucks by way of sheetmetal. This is most obvious from the front view, where the blocky and blingy GMC grille replaces the more subdued tone and shape seen on the Chevy's nose. Projector headlights with LED running lights come as standard, and, again, with the squared-off look that is typical of the brand. 16-inch aluminum wheels come stock on the GMC, too, with the 17-inchers seen on my photo truck offered as standard equipment on the top-trim SLT.
GMC considers the Canyon to be the only premium truck in the segment (which is clearly true), and the team has spent a ton of time and effort to get the interior correct to prove out that point. "Any trim that looks like metal, is metal," I was told at the product briefing, a certain indication that the company is serious about bringing a new class of buyer to a truck segment that it hopes to redefine.