1998 Gmc Sonoma Sl Standard Cab Pickup 2-door 2.2l on 2040-cars

Auto blog

GM Recalling Another 2.7 Million Vehicles In Five Separate Campaigns

The recalls keep rolling in from General Motors, evidently keen to avoid repeating the mistakes of the ignition-switch debacle and clean house. This time they're all coming at once, with five separate recalls announced together covering approximately 2.7 million vehicles. The largest of the five actions involves over 2.4 million units of the previous-generation Chevrolet Malibu and Malibu Maxx, Pontiac G6 and Saturn Aura in order to fix brake light wiring harness, which have been found to be susceptible to corrosion. The recall is separate from the 56k Aura sedans which GM recently recalled over faulty shift cables, not to mention the previous massive recall of 1.3 million vehicles – some of them the same models – but appears to have resulted from the National Highway Traffic Safety Administration investigation that started with the G6 almost a year ago. The second-largest campaign involves the 2014 Chevy Malibu, specifically those fitted with GM's 2.5-liter engine and stop/start system, approximately 140,000 examples of which has been found to have problematic brakes. The issue does not appear to be connected to the recall of 8k Malibu and Buick LaCrosse sedans (also involving brake woes) which we reported upon last week. Four crashes have been reported in such models, but GM admits it's not yet clear if the problem was a contributing factor in the accidents. A further 112k Corvette models from the 2005-2007 model years are being called in for problems with their low-beam headlamps resulting from a flexing relay control circuit wire that's not meant to bend. GM says it is "aware of several hundred complaints" about this issue, but notes that there have been no reports of related accidents. In addition, over 19k examples of Cadillac CTS from the 2013 and 2014 model years are being recalled over windshield wipers that might not work after a jump start. Finally, GM is also bringing in 477 examples of its 2014 Chevy Silverado, Tahoe and GMC Sierra (though not the Yukon) to fix a problem with a tie rod in its steering rack. As ever, all recall repairs will be performed free of charge, and GM is now estimating that recall-related actions this quarter will result in an estimated $200-million charge against its second-quarter earnings. Read the full announcement from GM below for further details.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Detroit 3 to implement delayed unified towing standards for 2015

Car buyers have a responsibility to be well-informed consumers. That's not always a very simple task, but some guidelines are self-evident. If you live in a very snowy climate, you generally know a Ford Mustang or Chevrolet Camaro might not be as viable a vehicle choice as an all-wheel drive Explorer or Traverse, for example. If you want a fuel-efficient car, it's generally a good idea to know the difference between a diesel and a hybrid. But what if it's kind of tough to be an informed consumer? What if the information you need is more difficult to come by, or worse, based on different standards for each vehicle? Well, in that case, you might be a truck shopper.
For years, customers of light-duty pickups have had to suffer through different ratings of towing capacities for each brand. For 2015 model year trucks, though, that will no longer be a problem. According to Automotive News, General Motors, Ford and Chrysler Group have announced that starting with next year's models, a common standard will be used to measure towing capacity. The Detroit Three will join Toyota, which adopted the Society of Automotive Engineers' so-called SAE J2807 standards way back in 2011.
The standard was originally supposed to be in place for MY2013, but concerns that it would lower the overall stated capacity for trucks led Detroit automakers to pass. Ford originally passed, claiming it'd wait until its new F-150 was launched to adopt the new standards, leading GM and Ram to follow suit. Nissan, meanwhile, has said it will adopt the new standards as its vehicles are updated, meaning the company's next-generation Titan should adhere to the same tow ratings as its competitors.