2003 Gmc Sierra 1500 4-door 4x4 Sle 5.3l V8 Z-71 Off-road Loaded Clean Carfax! on 2040-cars

Auto blog

Roadkill pits every project car against each other

The guys behind Motor Trend's monthly Roadkill series have collected nine of their favorite project cars from their videos and pitted them against each other in a battle royale to determine a winner. It's 44 minutes long, but it's completely worth the investment of time.
The cars run the gamut from a 1973 Chevrolet Ramp Truck, a 1975 AMC Pacer and a legitimately impressive 1967 Chevy Camaro, and they are pitted against each other to see which is the fastest around an autocross course. The drivers include Roadkill's two hosts and Motor Trend's Johnny Lieberman and Carlos Lago. It's reminiscent of the best episodes of Top Gear and worth a watch.
So it's the weekend - the perfect time to relax. Grab your preferred beverage, get comfortable and enjoy 44 minutes of some seriously ratty but utterly cool project cars as they are throttled within an inch of their lives (or past it). Scroll down to check out the video.

J.D. Power customer survey of dealers counts Cadillac, Buick as big winners

Cadillac and Buick have taken the trophies in J.D. Power's latest Customer Service Index Study examining satisfaction with dealer service. Surveying more than 90,000 owners and lessees of 2009-2013 model-year cars, the study found that those with pre-paid maintenance packages were ten percent more likely to buy their next car from the same brand.
Dealer satisfaction scores have improved overall, Cadillac nabbed the luxury segment ahead of Audi and Lexus, taking the crown that Lexus held last year. Buick keeps the mass-market dealer satisfaction win in the family, finishing ahead of Volkswagen and last year's winner GMC. The study also found that service department use of tablets increased customer satisfaction, as did "best practices" like "providing helpful advice." Who knew?
You can find details on those and more findings in the press release below.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck