1998 Gmc Sierra 1500 Ext Cab, 60k Original Miles, Must See! Excellent Condition on 2040-cars

Auto blog

GMC shows how the 2022 Hummer could have looked even more futuristic

Excitement filled the room when GMC asked its designers to resurrect the Hummer in April 2019, but a tinge of uneasiness permeated the department after executives locked in an early 2020 unveiling date. Luckily, stylists knew what they wanted early on in the development phase, and preliminary design sketches give us a fascinating look at how they shaped the electric off-roader that ended up making its global debut online in October 2020. Hummer, the brand, unceremoniously shut down in 2010 after General Motors failed to sell it to the Chinese, but its design DNA was so strong that stylists were able to pick up where their predecessors left off. All of the sketches published on Instagram by the official General Motors Design account show a boxy truck with a tall front end, a short windshield, and a generous amount of ground clearance. These styling cues trace their roots to the AM General Humvee that entered production in 1984 and made its combat debut when the United States invaded Panama in 1989. Even the wildest drawings still depict a pickup that's immediately recognizable as a Hummer. Most of the early design sketches wear some variation of the seven-slot grille that characterized Hummer's production models; it's a styling cue that hints at a heritage shared with Jeep under the American Motors Corporation (AMC) umbrella. Oddly, none wear the round headlights seen on the H2, the H3, and the HX concept that nearly became the H4. Was GMC afraid that its Hummer would end up looking too much like a Jeep? And, at least one sketch shows a fold-down windshield, a feature that will not make it to the assembly line. Sketches never reach production without modifications made in the name of packaging and safety concerns, and the Hummer is no exception, but stylists did a good job of reinventing the brand's design language without copying or erasing the past. If the company had stuck around long enough to make a second- and a third-generation H2, odds are it would look a lot like the GMC-branded model that will enter production in a year. GMC remains on track to start 2022 Hummer deliveries in late 2021, though it told Green Car Reports that it still hasn't built a fully functional prototype yet. When it arrives, this outdoorsy pickup will land in a burgeoning segment of the truck market that numerous models (including the Rivian R1T and Ford's electric F-150) will also call home.

GMC Syclone spools up a storm on Jay Leno's Garage

A storm was brewing on American roads in the early 1990s. That's when Detroit's automakers were producing some of the hottest performance trucks ever devised – models like the Ford Lightning, GMC Typhoon, and its flyweight pickup sibling, the GMC Syclone. Jay Leno just happens to have one of the latter in his garage, and took it out to showcase in this latest video segment. The Syclone was an exercise in absurdity, and could not only trounce any other pickup on the road, it could outrun anything else GM made and just about anything else on the road – beating Ferraris and Porsches off the line. In a pickup, for crying out loud. The kicker is that its engine wasn't such a monster, either: under the hood sat a 4.3-liter turbocharged V6 pumping out what would seem by today's standards to be an adequate 280 horsepower and 350 pound-feet of torque. Even the smaller of the EcoBoost V6s available in today's Ford F-150 produces more than that. But in a lightweight, compact pickup, those figures were enough to propel the Syclone to 60 in 4.3 seconds and run the quarter-mile in 13.6 seconds. Long before the dune-jumping Ford F-150 SVT Raptor or even the Viper-powered Dodge Ram SRT-10, GM made fewer than 3,000 Syclones based on the compact Sonoma (sister to the Chevy S-10) and another 4,700 of the Typhoon, which was mechanically similar but more practical (albeit heavier) wagon bodywork from the Jimmy. But as Jay aptly points out, the Syclone was the one you wanted. Scope it out in the ten-minute video clip above.

GM to build outgoing Silverado and Sierra until late 2019

As it has done with previous generations, General Motors is keeping the outgoing versions of its 1500 pickups in production despite the arrival of the all-new 2019 Chevrolet Silverado and 2019 GMC Sierra. The production of the previous, K2 generation models will begin to be wound down gradually, according to Automotive News, starting with crew cabs "early next year," and double and regular cab models following during "the early second half of next year." The old model trucks will continue to be built into "late 2019" based on market demand, GM's spokesperson Kim Carpenter said. The Chevrolet will go by the name Silverado LD, with the GMC Sierra designation still to be announced. Some of the outgoing models are built by sharing the assembly work between two GM plants. Partially finished Silverado and Sierra double cab bodies are shipped from Fort Wayne, Ind., to Oshawa, Ont., where the trucks are completed, including receiving paint. This eases the workload in Fort Wayne, where production of the new T1 generation trucks started in July 2018. In January, the Silao plant in Mexico will take on the duties of building new generation regular cab and crew cab trucks. Carpenter also said that the "Oshawa shuttle," as the shared production is called, has been very successful. As a result, 60,000 more trucks will be built than what the original production forecast initially called for. GM's latest quarterly profits, disclosed last week to be $1 billion, have been far higher than expected and will result in full-year profits far higher than what had been predicted in light of steel tariffs. GM isn't the only truck maker taking a similar multi-generation approach for 2019. Both the outgoing and redesigned Ram 1500 are in production, with the previous generation being dubbed Ram 1500 Classic. Related Video: