1967 Gmc Pickup on 2040-cars

Auto blog

GMC Syclone spools up a storm on Jay Leno's Garage

A storm was brewing on American roads in the early 1990s. That's when Detroit's automakers were producing some of the hottest performance trucks ever devised – models like the Ford Lightning, GMC Typhoon, and its flyweight pickup sibling, the GMC Syclone. Jay Leno just happens to have one of the latter in his garage, and took it out to showcase in this latest video segment. The Syclone was an exercise in absurdity, and could not only trounce any other pickup on the road, it could outrun anything else GM made and just about anything else on the road – beating Ferraris and Porsches off the line. In a pickup, for crying out loud. The kicker is that its engine wasn't such a monster, either: under the hood sat a 4.3-liter turbocharged V6 pumping out what would seem by today's standards to be an adequate 280 horsepower and 350 pound-feet of torque. Even the smaller of the EcoBoost V6s available in today's Ford F-150 produces more than that. But in a lightweight, compact pickup, those figures were enough to propel the Syclone to 60 in 4.3 seconds and run the quarter-mile in 13.6 seconds. Long before the dune-jumping Ford F-150 SVT Raptor or even the Viper-powered Dodge Ram SRT-10, GM made fewer than 3,000 Syclones based on the compact Sonoma (sister to the Chevy S-10) and another 4,700 of the Typhoon, which was mechanically similar but more practical (albeit heavier) wagon bodywork from the Jimmy. But as Jay aptly points out, the Syclone was the one you wanted. Scope it out in the ten-minute video clip above.

GM will no longer remove parts from trucks to calculate curb weights

Following last week's mild uproar after it was discovered that Ford and General Motors were removing some optional parts from their pickups to lower the curb weight and consequently increase the maximum payload, GM has come out and committed to a base curb weight for its upcoming Chevrolet Colorado and GMC Canyon compact trucks (although it has yet to publish them) and its current Silverado and Sierra. The company will do the same for its heavy duty offerings, although those numbers have not been finalized yet.
"This will make our curb weight and payload specs more consistent with those of most other truck makers, making it easier for customers to compare vehicles," GM spokesman Tom Wilkinson told Autoblog in an emailed statement.
As GM notes - and as every manufacturer has noted since this story broke - customers still shouldn't take max payload ratings as gospel. Instead, they should refer to their truck's Tire and Load Label, like the one shown at the inset, which will offer detailed information on max payload, specific to their truck.

Son surprises his dad by restoring his 1949 pickup for Christmas

Norman Meal, an 83-year-old retired farmer from Rushville, IN, nearly missed his big Christmas gift when his son, Kyle, first presented it to him. Norman was oblivious and was looking all over the garage floor until Kyle pointed out a satin black pickup with a bow on it parked inside. This wasn't just another case of a child buying a parent a dream vehicle; the '49 GMC sitting there was Norman's very first truck that was restored and ready to drive. According to Fox 59 WXIN, Norman's father purchased the GMC in 1949, and Norman bought it from him in the mid '50s to use on the farm. However, for about the past 13 years, the truck had been rotting away in the garage of one of Kyle's friends. As a perfect gift to his dad, Kyle took the pickup to a restoration shop to make the old vehicle roadworthy again. Practically everything was replaced – except for the horn. Thankfully, Kyle filmed his dad's reaction to getting the GMC. Check it out and watch them take a drive in the heartwarming video above.