2013 Ford Transit Connect Xlt on 2040-cars

Auto blog

Ford announces four recalls, 1.4M vehicles affected

Ford is taking a bit of the spotlight away from General Motors, announcing a major group of recall campaigns, covering a total of 1.4 million vehicles built between 2006 and 2013.
Let's start with the big one, which covers the Ford Escape, Mercury Mariner and, according to The Detroit News, Ford-built Mazda Tribute CUVs. 915,216 vehicles are covered, all of which were built in model years 2008 to 2011. 736,000 vehicles are in the US, while Canada then Mexico make up the vast majority of the remainder. The problem is due to an issue with the torque sensor in the steering column, which could lead to sudden power steering failure. Manual steering would still be available, though.
"Dealers will perform one of three service fixes, depending upon what diagnostic codes are shown when the vehicle is taken to the dealer," Ford spokeswoman Kelli Felker wrote to Autoblog in an email. "They will either update software for the power steering control module and the instrument cluster module; replace the torque sensor; or replace the steering column, which includes upgraded power steering control module software."

Recharge Wrap-up: Ford 1.0L EcoBoost a hit in Europe; Build a tiny inverter, win $1 million

In Europe, Ford's 1.0-liter EcoBoost engine is the best-selling turbocharged gasoline engine. The three-cylinder motor powers 20 percent of new Fords sold in Europe. Earlier this year, it won its third International Engine of the Year award, and between January and June, it was sold in about 120,000 cars. So far this year, 38 percent of Fords sold in the Netherlands, 35 percent in Denmark and 32 percent in Switzerland have been powered by the 1.0-liter EcoBoost. The engine's turbocharger spins at 248,000 rpm, and provides 24 psi of pressure. The engine produces up to 138 horsepower, depending on the version. Read more in the press release below. When lithium-ion battery packs are retired from the road, remanufacturing, repurposing, and recycling are worthwhile options, according to a study by Mineta Transportation Institute. The study included a cost-benefit analysis of those three options, and found remanufacturing to be the best route. To get the most out of them, batteries should be tested and have their damaged cells replaced then put back to use. Repurposing is the second best option, using the remaining available charge for something besides cars. Recycling on its own isn't profitable, but it could make economic sense with "increased technological breakthroughs." Learn more at Recycling International or download the report here. A smaller inverter for EVs can win you $1 million. The Little Box Challenge is an open competition to build a power inverter with a density of at least 50 watts per cubic inch. Google and the Institute of Electrical and Electronics Engineers (IEEE) are offering the hefty prize to the team that builds the inverter with the highest power density within an enclosed volume of 40 cubic inches. Teams must register by September 30. Read more at Green Car Congress or learn more at the Little Box Challenge website.

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.