1970 Ford Thunderbird on 2040-cars

Auto blog

Ford Fusion production scaled back just 3 months after it was accelerated

Three months after kicking off production of the Ford Fusion at its Flat Rock, MI factory, Ford Motor Company is taking steps to trim output in the face of heavily discounted competition from Toyota and a growing supply of vehicles.
The addition of Fusion production in Flat Rock - which also builds the Mustang - was meant to be what pushed the handsome mid-sizer past its arch-nemesis, the Toyota Camry. An extra facility building Fusions was also meant to curb the growing demand for Ford's highly profitable sedan.
But with word that Flat Rock would take "approximately" one extra week off for the holidays combined with an 88-day supply of Fusions - reportedly due in no small part to what Morgan Stanley analyst Adam Jonas called "aggressive discounting of the Camry" - some analysts are now beginning to wonder if Ford may have overextended itself by adding a second Fusion facility to the mix.

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Ford EcoBoost V6 hits the dyno before hitting the track

Ford Racing just unveiled the Riley Daytona Prototype that will make its racing in the United SportsCar Racing Championship Rolex 24 at Daytona in January, and now it has released a video showing development of twin-turbo 3.5-liter EcoBoost V6 that powers the car. Using the same block and heads that can be found on a production Ford Taurus SHO, this new racecar benefits from the collaboration between Ford Racing and Ford powertrain engineers.
While we still don't know what kind of power this engine is putting out, it has definitely gotten a workout at Ford's 17G dyno. This area deep within Ford allows the automaker's racing program to work hand-in-hand with production engine programs, which can be a benefit to racing operations and production cars alike. Scroll down to hear a few people from Ford talk about the crosspollination between its racing and engine teams and watch the EcoBoost get red hot on the dyno.