1962 Rare Ford Thunderbird With Ac & Factory Wire Whls, Black/red on 2040-cars

Auto blog

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford to auction Mustang Cobra Jet prototype for charity [w/video]

Prototypes developed by major automakers typically remain in said company's custody, but every once in a while, one trickles out into private hands. And that's just what we have here. Ford is donating a one-of-a-kind factory prototype for the 2014 Mustang Cobra Jet that will be auctioned off later this month by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society.
Powered by a 5.0-liter supercharged V8 mated to a T4 competition gearbox, this rare Cobra Jet prototype includes a wheelie bar, chromoly roll cage, Weld wheels, three-link rear suspension, racing brakes, 9-inch rear axle and more. It's painted in a unique satin orange with reflective gray striping scheme, bears the serial number 2014 BJMS CJXX1 and is fully ready for NHRA competition on the drag strip.
To be offered with no reserve on Saturday, September 28, 2013, the Cobra Jet prototype's winning bidder will also receive tutelage at Roy Hill's Drag Racing School in Sophia, NC, along with tours of the Ford Product Development Center, Ford Racing headquarters and Ford Design Studios with Mustang chief engineer Dave Pericak. Scope out the video and details below for what could be the ultimate Mustang experience for a good cause.

VW going turbo-only in 3 to 4 years

This really was a matter of when, rather than if. Volkswagen will apparently be the first manufacturer to phase out naturally aspirated engines in favor of turbocharging its full slate. VW is kind of responsible for ushering in this push towards small-displacement, turbocharged engines that's taken the industry by storm. When it dropped its direct-injection, 2.0-liter turbo in the 2005 GTI it demonstrated that strapping an iron long to an engine can enhance the powertrain as a whole. VW made fuel economy gains, while also giving a linear, non-laggy turbo experience that it has replicated, model-after-model, to this day.
Speaking with The Detroit News, Volkswagen's executive Vice President of Group Quality, Marc Trahan, told the paper that, "We only have one normally aspirated gas engine, and when we go to the next generation vehicle that it's in, it will be replaced. So three, four years maximum."
Really, it's hard to get teary-eyed about either of these engines going away. VW has access to smaller powerplants that could easily match the performance of the 2.5 five-cylinder and the 3.6 V6, while gobbling up less fuel and providing a better driving experience. What we are sad about is that a similar statement about the extinction of NA engines came from the Vice President of Powertrain Engineering at Ford, Joe Bakaj. We'd certainly get teary-eyed over a world without Ford's excellent 5.0-liter V8.