1957 Ford Thunderbird Base Convertible 2-door 5.1l on 2040-cars

Auto blog

NHTSA closes probes on Jeep Grand Cherokee, Ford Freestar and Mercury Monterey

The Detroit News reports the National Highway Traffic Safety Administration has officially closed its investigations into 2012 Jeep Grand Cherokee, 2004-2005 Ford Freestar and Mercury Monterey models. The separate probes found no issues that pose safety concerns. NHTSA began investigating certain Grand Cherokee SUVs over complaints that power steering hoses could detach during operation, thereby increasing the risk of a vehicle fire. Of the 24 reports of failure, none alleged smoke or fire in the engine bay, and Chrysler has since modified the power steering cooler assembly to reduce the likelihood of the failure.
Meanwhile, certain Ford Freestar and Mercury Monterey vehicles garnered a government probe after receiving complaints that the models were equipped with faulty scissor jacks. The agency had received six reports of the jacks failing or causing injuries, including one incident that resulted in a fatality. But NHTSA says the jack failure rate is similar to those found in other vehicles. In those six cases, the government agency found the jacks were being used for something other than changing a tire, and investigators could not determine whether the emergency brake was set or the rear tires were properly chocked.

Would a Mustang-based Lincoln look like this?

Designer Josiah LaCalla has taken a stab at what a Ford Mustang-based Lincoln model might look like with the Continental Mark X1 concept. Make no mistake, Ford's luxury arm has made it abundantly clear that it won't be pursuing any new products outside of volume models, which means a flashy halo grand tourer like the one you see here isn't in the cards. LaColla used the Mercedes-Benz SLS AMG as a basis for his creation, which explains the long nose, but we certainly don't mind the idea of a rear-wheel drive Lincoln with a cabin pushed to the aft.
While we're dreaming, there's certainly nothing stopping us from imagining what's under that lengthy hood. We like the idea of the 5.8-liter supercharged V8 from the Shelby GT500 pushing the Mark X1 down the road, but how about something a little more inventive? Something like a high-revving, buttery V12 with enough torque to push the contraption well past 200 miles per hour. Dream a little dream, people.

This is what a 3D-printed liquid metal Ford Torino looks like

Artist Ioan Florea has encapsulated a 1971 Ford Torino with 3-D-printed liquid metal transferred onto the car using technology that he developed, and the result is a stunningly shiny, seamless design.
"The surface has the highest coefficient of reflectivity never achieved before," Florea told us in an e-mail, using "nano-materials and nano-pigments that create an internal three-dimensional structure and dictate the polymer how to behave." Sure... We'll leave it to him to make any more 3-D-printed liquid metal-transferred art pieces.
Florea grew up in Romania, and the motivation behind picking the old Ford as his canvas came from his childhood memories of what an American car is - "big and wide and fascinating," he says - and the European name of the car itself, which it shares with an Italian city.