2002 Ford Taurus Se,cd,loaded,great Car,low Miles,no Reserve!!! on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford and Lincoln recall roundup: Explorer, F-350 Super Duty, Aviator

Ford and Lincoln released information on a flurry of recalls this morning. There are three in total, and they span different models and separate issues. Those models include the 2013-17 Ford Explorer, 2020-21 Lincoln Aviator and 2020-21 Ford F-350 Super Duty. We’ll organize these three in order of most cars recalled. 2013-17 Ford Explorer This recall includes a substantial 774,696 vehicles, of which 676,152 are in North America. Why? Ford says these vehicles “may experience a seized cross-axis ball joint that may cause a fractured rear suspension toe link.” The diminished steering control that would follow could increase the likelihood of a crash, Ford states. Only vehicles that spent time in high corrosion states should be affected, Ford says. That means places that lay salt down, experience cold weather and high humidity. Owners of these vehicles will need to take their car into the dealership, where it will be inspected to determine if it needs work. If so, Ford will replace the cross-axis ball joint/knuckle, then replace the toe links with a newly-designed part. Notifications to owners of these vehicles are scheduled to be sent out the week of August 23.  WeÂ’ll note that Ford is reporting six “allegations of injury” related to this issue. For those who donÂ’t live in the high-corrosion states/their car was never registered in those states, Ford is offering a customer satisfaction program in case you were interested in having the work done anyway. 2020-21 Lincoln Aviator Lincoln is pulling back 40,995 new Aviators due to an improperly secured battery cable wire harness. This recall applies to gasoline-only versions of the Aviator, so Grand Touring PHEV buyers neednÂ’t worry. The wire harness may contact the AC compressor pulley due to it being secured improperly. Ford says that over time, the pulley could rub through the wire harnessÂ’ insulation, resulting in a short circuit and ultimately a fire. However, Ford is not currently aware of any injuries or fires related to this concern as of now. When you bring your car in, the dealer will inspect all the parts to determine what needs to be done. Fixes range from a basic tie strap to keep the harness away from the pulley (if it hasnÂ’t made contact yet), to replacement of the wire harness and AC belt if the contact has caused damage. Owners should expect to be notified the week of July 30 if their Aviator is involved in the recall.

Trump did talk to Bill Ford, but the Kentucky plant was never moving to Mexico

President-elect Donald J. Trump has been butting heads with Ford for a while now. A lot of it seems to stem from misunderstanding or misrepresenting facts about how the automaker currently does business and its plans for the future. After a sit-down with executive chairman Bill Ford Jr., the misunderstandings continue, but Trump has apparently convinced the company to make some changes. During his campaign, Trump claimed that Ford was going to fire US workers and move manufacturing to Mexico. That wasn't the case – yes, Ford planned to transfer Focus and C-Max production from Wayne, Michigan, to Cuautitlan, Mexico, but no, that wouldn't mean anyone losing their job. The Wayne plant will continue to operate, and likely busier than before, as it will be the home of the new Bronco and Ranger. So Ford CEO Mark Fields responded with the facts, and then chairman Bill Ford Jr. sat down with Trump over the summer. Things apparently weren't resolved to Trump's satisfaction, so he and Bill Ford spoke on the phone yesterday as he claims in this tweet: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Let's pick that apart. First off, it's not a Lincoln plant, per se – the Louisville Assembly Plant currently builds the Ford Escape and Lincoln MKC, two small crossovers that share a platform. Ford was considering moving MKC production out of Kentucky to Mexico, but it would not have resulted in many lost jobs if any – the union had already agreed to moving the MKC in 2015 negotiations, and taking production of the slow-selling Lincoln out of the plant would open up capacity for more Fords. Be that as it may, Ford has decided not to move MKC production out of the plant, either for political reasons of placation or because it didn't make the greatest deal of business sense, maybe a combination of the two. That means Trump isn't really saving any American jobs in the short term. If anything, this move could keep Ford supply-constrained and result in reduced sales, which in turn brings the company less money and affects the bottom line and all employees. But that's speculation, so we won't tweet it. There is of course the possibility that Ford will be convinced, either by sheer will or by a more attractive trade situation, to invest in increased US production, which could bear fruit later on. We are told by Ford that the two men did in fact speak yesterday.