Chopped 1935 Ford Truck on 2040-cars
Naples, Florida, United States
Vehicle Title:Clear
Fuel Type:Gasoline
Engine:4 Cyl
For Sale By:Private Seller
Transmission:Manual
Model: Other Pickups
Trim: 2 Door
Drive Type: Rear wheel drive
Disability Equipped: No
Exterior Color: Burgundy
Warranty: Vehicle does NOT have an existing warranty
Interior Color: black and white
Mileage: 10,000
Ford Other Pickups for Sale
- 1955 ford c600 cab over
- 1951 f6 ford truck trailer toter(US $2,500.00)
- Must see this ford one owner f-450 utility bed with crane fully service(US $21,800.00)
- Ford f550. 200k miles. set up as a service truck. starts and runs great(US $8,000.00)
- 1941 ford pickup - hotrod, classic truck(US $90,000.00)
- 1932 ford gasser old scool build rat rod truck roadster
Auto Services in Florida
Zip Automotive ★★★★★
X-Lent Auto Body, Inc. ★★★★★
Wilde Jaguar of Sarasota ★★★★★
Wheeler Power Products ★★★★★
Westland Motors R C P Inc ★★★★★
West Coast Collision Center ★★★★★
Auto blog
NHTSA closes Ford F-Series Super Duty steering probe without recall
Wed, 05 Feb 2014The National Highway Traffic Safety Administration's investigation into 2008 Ford F-250 and F-350 Super Duty pickups, which was originally opened last year, has now ended without a recall. NHTSA was looking into steering failures on some 336,000 trucks.
The issue rested with the steering gear - NHTSA received five complaints of failures - which was redesigned in 2005. According to the report on the matter, investigators "found evidence of broken sector shaft gear teeth and piston damage consistent with incidents of single event overload."
NHTSA investigators, however, "found no evidence of fatigue or material property defects in any of the fractures. Analysis of complaint rates by vehicle build month showed no patterns indicating potential manufacturing quality issues and no difference before and after Ford introduced design changes to the input shaft and sector shaft seals in July 2007 to address potential leak concerns," according to the report, obtained by The Detroit News.
NHTSA upgrades Ford floor mat unintended acceleration probe
Mon, 17 Dec 2012According to a Bloomberg report, the National Highway Traffic Safety Administration has upgraded an investigation into complaints of unintended acceleration lodged against Ford vehicles. The investigation began in June of 2010 when just three complaints had been received and it only concerned the Ford Fusion and Mercury Milan, but this was at a time when the phrase "unintended acceleration" made grown men go pale. With 49 additional complaints received since then, the investigation has been reclassified as an engineering analysis - the last phase before a recall - and it has been expanded to include the Lincoln MKZ, making for a total of "around 480,000" units affected between the three sedans from the 2008 to 2010 model years.
The ostensible cause is that floor mats are trapping the accelerator pedal, but according to a Ford statement at the time, the entrapment is due to owners placing the optional all-weather floor mats, or aftermarket floor mats, on top of the car's standard floor mats. NHTSA has backed up that assessment, pinning the blame on "unsecured or double stacked floor mats."
On the face of it, it would appear that NHTSA has upgraded the status not because of Ford's error, but owner error, and Ford has stated publicly that it is "disappointed" in NHTSA's move. On top of NHTSA still being skittish after that other unintended acceleration debacle, it could be seen to be taking its time investigating all of the variables: it's reported that Ford changed its accelerator pedal design in 2010, a "heel blocker" in the floorpan has been considered a potential culprit in how the floor mats could be trapping the pedal, some drivers have said the floor mats weren't anywhere near the pedal, and according to a report in the LA Times, in "a letter sent by Ford to NHTSA in August 2010, the automaker said it found three injuries and one fatality that 'may have resulted from the alleged defect.'"
Ford invests $682 million in Edge-producing Canadian facility
Sun, 22 Sep 2013Ford announced that it's investing $682 million in its Oakville assembly plant in Ontario, Canada, to make it a global manufacturing plant, which the automaker also says secures 2,800 jobs there. Including this injection of cash, Ford has invested over $2 billion in Canada in the last decade, starting with nearly $1 billion for Oakville in 2004, and over $570 million for its Essex Engine Plant in 2010.
The move to make Oakville a global manufacturer of Ford vehicles means, "If consumers suddenly shift their buying habits, we can seamlessly change our production mix without having to idle a plant," says Joe Hinrichs, Ford's president of the Americas.
Ford says that the latest investment will help it meet North American demand for the Oakville-produced Edge crossover, which is on track this year to beat 2007's US sales record of 130,000 Edges. The Ford Flex and Lincoln MKX and MKT are also manufactured at the plant.