1949 Ford Pickup on 2040-cars

Auto blog

Next Ford F-150 delayed for aluminum body panel issues?

The timetable for next-generation Ford F-150 may be in trouble if a report from The Truth About Cars is true. The next F-150 is slated to make extensive use of weight-saving aluminum in its body, but the aluminum alloy provided by suppliers hasn't met Ford's requirements in the earliest phases of pre-production, according to the report.
The F-150 represents a huge portion of Ford's profits and is the best-selling truck in the US, even in the face of increased pressure from cross-town rivals General Motors and Ram. While the current truck is treading water against its competition, we'd be lying if we said the F-150 weren't growing quite long in the tooth.
If production of the next-generation of the Ford cash cow, said to be based on the Atlas Concept from the 2013 Detroit Auto Show (pictured above), is delayed, it could be bad for Ford. Production at Ford's Dearborn Truck Plant is already set to be delayed six to ten weeks, missing an internal on-sale deadline of Memorial Day.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

2015 Ford Mustang production to begin on July 14? Not quite, says Ford

Mustang6g.com believes that it has unlocked start date for 2015 Ford Mustang production citing a Ford dealer communiqué. According to the report, job one on the 2015 hardtop will allegedly start in just a few days, on July 14, although units that are known as "OK to Buy" won't enter production until September 9. The cars built between those dates are most likely final pre-production cars for the executive test fleet, and will likely include the cars we'll be driving at the media launch.
Sun worshippers, meanwhile, would seem to have a longer wait. Job one on the droptop supposedly isn't slated to start until September 14, with production models starting on October 27. As is the case with the hardtop, these final pre-pros are for the execs and media to test, while actual dealer orders will come from vehicles made after the October date.
After speaking to Ford, though, we wouldn't put a great deal of stock in those dates as reported. We reached out to Said Deep, Ford's North American Product Communications Manager.