2014 Ford Mustang Shelby Gt500 on 2040-cars

Auto blog

2015 Ford Mustang production to begin on July 14? Not quite, says Ford

Mustang6g.com believes that it has unlocked start date for 2015 Ford Mustang production citing a Ford dealer communiqué. According to the report, job one on the 2015 hardtop will allegedly start in just a few days, on July 14, although units that are known as "OK to Buy" won't enter production until September 9. The cars built between those dates are most likely final pre-production cars for the executive test fleet, and will likely include the cars we'll be driving at the media launch.
Sun worshippers, meanwhile, would seem to have a longer wait. Job one on the droptop supposedly isn't slated to start until September 14, with production models starting on October 27. As is the case with the hardtop, these final pre-pros are for the execs and media to test, while actual dealer orders will come from vehicles made after the October date.
After speaking to Ford, though, we wouldn't put a great deal of stock in those dates as reported. We reached out to Said Deep, Ford's North American Product Communications Manager.

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.