2012 Ford Mustang Premium Gt on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford taken to task by gov't for Chicken Tax end-around

Ford is in a bit of a pickle for importing and selling Turkey-built Transit Connect cargo vans as passenger vehicles in the US, then converting them to commercial-vehicle specification stateside in an effort to bypass a 25-percent tax imposed on vehicles imported for commercial use. Automakers are required to pay a 2.5-percent tax on imported passenger vehicles.
The Blue Oval got into trouble for this in a January ruling in which U.S. Customs and Border Protection officials asked Ford to stop the practice of importing the Transit Connect vehicles with passenger seats, then removing and shredding them. Now Automotive News reports that Ford is appealing the ruling. The 25-percent "Chicken Tax," as the tariff is often called, is 50 years old and was enacted as a response to a German tariff on chickens. Like Ford, Chrysler bypasses the higher tariff, but it does so in a different manner. It partially disassembles Sprinter cargo vans before shipping them to the US, then rebuilds them at a plant in South Carolina.
But the ruling against Ford's strategy states that it "serves no manufacturing or commercial purpose" and is there to "manipulate the tariff schedule," Automotive News reports. As Ford's appeal goes through, it is importing the Transit Connect and paying the higher tax, hoping for a favorable outcome and planning to build the next-generation Transit Connect, which it plans to launch before the end of the year, in Spain.

Automotive Grade Linux will be the backbone of your connected car

Creating a backend for a secure, reliable, and expandable infotainment system is costly and time consuming. The Linux Foundation, a non-profit organization, has set out to promote and advance the Linux operating system in commercial products. Automotive Grade Linux, or AGL, is a group within the Foundation that seeks to apply a Linux backend to a number of automotive applications in a variety of vehicles from various suppliers and manufacturers. AGL's goal is to create a common, unifying framework that allows developers and manufacturers to easily implement applications across platforms. Currently, the focus is on infotainment systems, but AGL has plans for instrument clusters, heads-up displays, and eventually active safety software. At CES, a display from Panasonic showed a completely digital and customizable dashboard that allows information and apps to be moved from the gauge cluster to the infotainment screen and back, all through the use of gesture and touch controls. Although the organization has been around for five years, it's really only been in the past three that the group has been working hand in hand with automakers and suppliers. The first two OEMs to participate, Toyota and Jaguar Land Rover, have since been joined by Mazda, Suzuki, Ford, and, as of this week, Daimler. The latter is important as until now most of AGL's partner's have been based in Japan or the US. Other partners include suppliers Denso, Renesas, Continental, Qualcomm, and Intel. AGL want's to supply roughly 80 percent of the backend, allowing partners to then finish and refine the Linux system for each individual application. Think of how the Android operating system is refined and customized for individual smartphones from Samsung, LG, and Motorola. While the final product looks different, developers can have an application that will work across all AGL systems. Because it is open source, anyone can use and develop for AGL. You can even go onto the group's website and download a copy right now. There is also a software development kit available that helps facilitate app creation on the platform. Vehicle development cycles take roughly five years, so there currently are no cars that run an AGL backbone available for consumers. AGL Executive Director Dan Cauchy says products should be hitting the market later this year, with even more coming in 2018. Right now, the industry is relatively fragmented when it comes to infotainment and related systems.