2005 Ford Mustang Gt Shelby Clone, 425hp, Borla Exhaust, Black/black, 5spd on 2040-cars

Auto blog

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.

2014 Ford Mustang GT

I was more than a year removed from my last experience with the Mustang GT and its delicious 5.0 V8 when this new 2014 example rolled up to my driveway recently. Good weather and a planned road trip across the state meant that I would get plenty of seat time in this conservatively specified example, too. In total, I logged about 400 miles in a week of driving - not a lot for some of you super commuters out there, but quite a lot for this work-from-home journalist.
The basic formula of the 5.0 has stayed the same for 2014. The 2013 model year saw a number of updates to keep the Mustang fresh until it's replaced with an all-new generation for 2015. So, for its bon voyage tour, the fifth-generation Pony Car has seen only a few modifications: a couple of new paint colors (Oxford White and Ruby Read Metallic), trim and wheel revisions and, sadly, the deletion of the Boss 302 from the Ford lineup. However, while the limited-edition Boss is likely to reappear sometime after the gen-six Mustang makes its debut in 2015, the GT Track Package cars like the one I tested provide at least a partial solution for those looking for hot laps.
Driving Notes

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.