1967 Ford Mustang 2dr on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

2015 Ford Mustang to offer solid-rear axle, sort of

One of the biggest knocks against the last Ford Mustang was its solid-rear axle. Not one to actively court criticism, Ford dutifully swapped out the old-fashioned rear end for something a bit more modern in the redesigned 2015 Mustang, adding an independent rear suspension across the board.
While an IRS Mustang is great news for those that value handling and ride comfort, there's one big group that it's bad news for - drag racers. See, a solid-rear axle is a big deal for drag racers, because not only is it more durable and cheaper, but it's better for the hard launches that can make or break a race.
To satiate this vocal demographic, Ford will sell a body-in-white version of the Stang, complete with a nine-inch rear axle, that will debut at the 2014 Performance Racing Industry show. The news came from gas2.org, which cited an unnamed employee of Ford Racing at this year's PRI show.

Kawei K1 pickup blatantly copies Ford F-150

The Chinese auto industry used to be looked at as a joke full of products blatantly copied from foreign vehicles. However, companies like Qoros and others show that the country's automakers have taken big steps in terms of original design. It doesn't look like every automaker there is ready to put down the tracing paper yet, though. Case in point: The Kawei K1 pickup pictured above, which is an obvious rip-off of the Ford F-150. In fact, the company isn't even hiding it. Kawei deserves a little credit for its openness. In describing the new model, it says: "No matter the black net grille and the outline of the headlamp, even if the styles of fog lamp and engine cover, it looks the same as Ford Raptor." It also admits that spelling out the model name on the hood is inspired by Land Rover. It's available with either a 2.4-liter, gasoline-fueled four-cylinder producing 141 horsepower and 148 pound-feet of torque (elsewhere it also lists it as having 162 lb-ft) or a 3.2-liter six-cylinder diesel with 106 hp and 181 lb-ft. Regardless of engine, power is sent to the rear wheels through a five-speed manual gearbox. The trucks cost around 100,000 Yuan ($16,033). So at least the K1 is a reasonably priced knockoff. According to Car News China, the K1 is actually selling in small numbers. The company made 10,000 of them last year and even exported some to Africa and the Middle East. Kawei's factory is doubling in capacity this year to build even more. You can read more about the truck on the company's website in some very mangled English. Featured Gallery Kawei K1 Pickup View 11 Photos News Source: Kawei via Car News ChinaImage Credit: Kawei Beijing Motor Show Ford Truck Diesel Vehicles Beijing 2014