1966 Ford Mustang on 2040-cars

Auto blog

Ford recalls Five Hundred, Mercury Montego sedans over fuel tank woes

Ford has announced through the National Highway Traffic Safety Administration that it is recalling nearly 3,000 examples of its Five Hundred and Mercury Montego (pictured) sedans from the 2007 model year.
The action, which affects 2,945 vehicles, is due to potentially defective welds between the filler neck and the fuel tank, a condition that could result in a fuel leak or the smell of gasoline reaching the occupants. In the worst-case scenario, a leak could cause a fire. Cars with the affected fuel tank problem could see an illuminated dashboard warning light as a result of the evaporative emissions leak being detected.
Ford will inspect and replace the fuel tank at no cost to owners (those who have already had the procedure done at-cost can apply for reimbursement), and the Dearborn automaker will begin notifying Five Hundred and Montego owners beginning August 15. Check out the official NHTSA press release after the jump for further details.

Ford hybrid sales rebound following MPG controversy

Ford hybrid customers apparently have very short memories. With two EPA fuel economy reratings in the last year, sales of the C-Max, Fusion Hybrid and Lincoln MKZ haven't been too terribly dented, Ward's Auto reports.
All three vehicles saw sales dips following the August 2013 rerating, although sales of the MKZ Hybrid had begun to rebound as early as November of that year. C-Max sales, meanwhile, took slightly longer, with sales on a steadily improving course as early as February of this year.
The second rerating, in June of this year, has had an even smaller effect on the Blue Oval's hybrids. The C-Max has actually been subject to a sales increase, while both the MKZ and Fusion saw minor sales drops (less than 400 units between the two in the month following the rerating).

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).