1965 Ford Mustang on 2040-cars

Auto blog

These horribly misguided front-drive design studies nearly became the Mustang

As we eagerly await the unveiling of the all-new sixth-generation Mustang, Ford has been giving us some great information over the past few months showing what has gone into shaping its venerable pony car. As many changes as the Mustang has gone through in its 50 years, though, it appears the fourth-gen model played a decisive and pivotal role in the car's future.
As is part of Mustang lore, the front-wheel drive Ford Probe was originally developed as a next-generation Mustang in the Eighties before cooler heads prevailed. The Blue Oval has just released a handful of images showing how bad things could have been - including a full-scale clay model of a front-wheel-drive Mustang (shown above). Fortunately, the FWD Mustang plan was scrapped and Ford went to work designing a rear-wheel-drive replacement for the Fox Body Mustang, with three design studies making it far enough to become full-scale models. These include the soft "Bruce Jenner" Mustang, the over-the-top "Rambo" Mustang and the middle-ground "Arnold Schwarzenegger" Mustang, which finally became the basis for the 1994 'Stang.
By early 1991, the design language of the fourth-generation Mustang had been worked out, and the rest, they say, is history. Scroll down for the fascinating press release telling the story of the fourth-gen Mustang, and be sure to check out the gallery of horribly misguided sketches and various design studies that were all on the table in the late 1980s.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.