1923 - Ford Model T on 2040-cars

Auto blog

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.

Junkyard Gem: 1991 Mercury Grand Marquis LS

Ford's now-defunct Mercury Division first began using the Marquis name in 1967, on a sporty full-size hardtop based on the Ford LTD, then began offering the Grand Marquis beginning in the 1979 model year. These big, boxy luxury sedans were replaced by big, curvy luxury sedans (on the same platform) starting with the 1992 model year, so today's Junkyard Gem is one of the very last squared-off Grand Marquises ever built. The 1991 Grand Marquis (or "Grandma Keith," as many refer to it today) looks nearly identical to its 1979 predecessor at a glance, just as the 2011 model doesn't differ much from the 1992 model. Ford saw no reason to follow short-lived fashion trends with its simple, sturdy rear-wheel-drive sedan. Only two Grand Marquis trim levels were available for 1991: the base GS and the (somewhat) upscale LS. The former listed at $18,741 and the latter at $19,241, which comes to about $41,494 and $42,601, respectively, in inflated 2022 dollars). This interior would have seemed comfortingly familiar to a 1968 (or even 1958) Mercury owner time-traveling to 1991.  This is the optional "full grain leather seating surface," which cost an extra $489 (about $1,083 today). Dig those opera lights! Air conditioning was standard equipment in the 1991 Grand Marquis and its wagon counterpart, the Colony Park. The engine is the good old pushrod 5.0-liter Windsor V8, which would be replaced by a far more modern 4.6-liter SOHC mill in the '92 Grand Marquis. This engine was rated at 180 horsepower. A four-speed automatic was the only transmission available. The early 1990s ended up being the last gasp for padded vinyl roofs being considered mainstream equipment on new Detroit cars; this one was called the "Formal Coach" roof and cost an additional 725 bucks ($1,605 now). Such roofs were still available on a few cars later in the decade, but their time had passed. Why would such a clean Grandma Keith end up in a place like this? That's easy: it got T-boned directly into the right front wheel, mangling the body and bending up the suspension. This damage might have been worth fixing when the car was five years old, but it's a write-off when it happens to a 31-year-old Ford Panther. 1991 Mercury Grand Marquis Commercial - Savings Ad The granddaddy of them all, and on sale in South Texas! Related video: 2008 Mercury Mariner Hybrid test drive Autoblog

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).