1916 Ford Model T Roadster Project. Original Engine! on 2040-cars

Auto blog

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.

Ford Fiesta ST customs get wild at SEMA

The massive 57-car SEMA showcase by Ford ranges from obvious aftermarket-friendly models like the Mustang, to the not so obvious ones, like the Transit Connect and cute-as-an-explosive-button Fiesta ST. Ford plucked several Fiesta STs for SEMA duty, and we were on the show floor today to get a closer look at some of them.
First up is the striking COBB Tuning and Tanner Foust Racing Fiesta ST (above) finished in a black-and-gray digital camouflage, much like that used in the military, and is meant to raise awareness for the Pat Tillman Foundation. COBB also fitted a three-inch exhaust and a cold-air intake. A new shift knob, carbon-fiber hood and a Kicker stereo round out the mix of upgrades.
MRT got its hands on a Fiesta ST and created a car inspired by Forza Motorsport 5 (below, left). Featuring a two-tone paint job and more performance upgrades than you can shake a stick at, this Fiesta ST is one of the cooler compacts at Ford's stand. A high-performance exhaust system, along with a complimentary COBB induction system, allows the ST to breathe better, while an H&R coil over suspension and Steeda brakes help it stop and turn better than stock.

2014 Ford Transit unveiled in Chassis Cab and Cutaway versions

As a leader in commercial vehicles here in the US, we knew Ford wouldn't take too long to show off the chassis cab and cutaway versions of its 2014 Ford Transit van. Set to go on sale this fall, Ford already revealed the full-body version of the Transit, and now it has pulled the cover off exposed-frame models just in time to to compete against the all-new Ram Promaster.
The term "chassis cab" refers to models with a fully enclosed cabin used for box vans or rental trucks, while cutaway models leave the cabin open behind the B-pillars for a pass-through on vehicles such as Class C motorhomes or ambulances. Both will offer three wheelbase options (138, 156 and 178 inches), the choice of single or dually rear axles, and plenty of upfitter-friendly touches including a pre-wired body harness and multiple body mount locations.
The new design will also help make upfitting a little easier since the fuel filler is now built into the cab (just behind the driver's door). Those integrated fuel filler necks will serve to feed either a 3.7-liter V6, a 3.5-liter EcoBoost V6, or a 3.2-liter Power Stroke diesel. Transit chassis cab and cutaways will wear varying Gross vehicle weight ratings from 9,000 pounds to 10,360 pounds depending on spec.