2014 Ford Fusion Titanium on 2040-cars
602 W Rose Ave, Crane, Missouri, United States
Engine:2.0L I4 16V GDI DOHC Turbo
Transmission:6-Speed Automatic
VIN (Vehicle Identification Number): 3FA6P0K91ER281675
Stock Num: 14882
Make: Ford
Model: Fusion Titanium
Year: 2014
Exterior Color: Deep Impact Blue Metallic
Interior Color: Charcoal Black
Options: Drive Type: FWD
Number of Doors: 4 Doors
Ford Fusion for Sale
- 2014 ford fusion hybrid se(US $33,910.00)
- 2014 ford fusion energi se luxury(US $35,600.00)
- 2014 ford fusion titanium(US $35,875.00)
- 2014 ford fusion se(US $30,185.00)
- 2014 ford fusion hybrid se(US $33,245.00)
- 2014 ford fusion se(US $27,025.00)
Auto Services in Missouri
Unnerstall Tire & Muffler ★★★★★
Tim`s Automotive ★★★★★
St Charles Foreign Car Inc ★★★★★
Scherer Auto Service ★★★★★
Rogers Auto Center ★★★★★
Rev Diy Automotive Repair ★★★★★
Auto blog
Consumer Reports declares most and least loved cars [w/video]
Wed, Dec 3 2014Consumer Reports is crunching the numbers from its annual owner-satisfaction survey, and part of that process is finding out how attached drivers are to their cars. CR simply asks readers of models up to three years old if they would buy the same vehicle again in light of their entire ownership experience, and tallies the results. After looking at the responses for about 350,000 vehicles, it turns out that people really love a certain California-built, electrically powered luxury sedan. That's right, this year's the overall winner was the Tesla Model S with a whopping 98 percent of owners saying they would purchase another one (the Model S also won this award last year, with 99 percent satisfaction). The Chevrolet Corvette Stingray came in a close second with 95 percent of drivers hoping to park another one in their garage. A few models weren't quite so favored, though. The Nissan Versa Sedan was the least loved model among its owners; a mere 42 percent said that they would purchase another. The aging Jeep Compass didn't do much better, with just 43 percent of drivers willing to buy the softroader again. On average, about 70 percent of owners say they would buy their car again, and only four cars ranked below 50 percent in CR's findings. Check out the video above to see some of the winners and losers in a few of CR's categories. If you're a subscriber, you can check out the full list on its website. Related Gallery Consumer Reports Most Loved Cars 2014 Related Gallery Consumer Reports Least Loved Cars 2014 News Source: Consumer Reports - sub. req., Consumer Reports via YouTube Chevrolet Ford Mazda Mercedes-Benz Porsche Subaru Tesla Ownership Videos car ownership
The 1965 Ford Mustang could have looked a lot different
Fri, May 8 2020The 1965 Ford Mustang is unquestionably an automotive design icon, and nearly every generation of Mustang has some connection to that original car. Because it's such a universally-known vehicle, we were amazed to see all the different designs that were being considered. Head of Ford's archives Ted Ryan recently shared photos of design proposals for the original Mustang on Twitter that he and Jamie Myler found, and we reached out to them to find out more. As Ryan initially noted, the photos were taken on August 19, 1962, and they are proposals for the Ford Mustang. Apparently Ford had committed to doing a Falcon-based youth-oriented car at this point, and it did have plans to launch the car in 1964 for the 1965 model year. But after having little success with early design proposals, the company asked all of its design studios — the Advanced Studio, Lincoln-Mercury Studio and Ford Studio — to submit proposals. With only about two years before the planned launch, Ford was understandably short on time, and it's believed that the studios only had a month to create and present these designs. Lincoln-Mercury design proposal View 8 Photos The majority of the designs, a total of five, came from the Advanced Studio, and part of this was because they already had a couple of concept designs in reserve it could present. Two other models representing three design possibilities came from Lincoln-Mercury, and just one model with two options came from Ford. The Advanced Studio proposals are shown in the gallery at the very top of this article, and the Lincoln-Mercury and Ford proposals are in the gallery directly above this paragraph. The Advanced Studio's most radical design is the one that was clearly related to the Mustang I concept that would be shown later that year with huge wraparound rear glass, turbine-inspired bumpers and enormous side scoops. The other proposals from the studio were more conservative, featuring simple lines, grilles reminiscent of the Falcon, and one even borrowing the jet-thruster-style taillights made famous on the Thunderbird. Lincoln-Mercury had some impressively bold designs, particularly its fastback that had buttresses to extend the shape all the way to the tail. This car had two different side trim possibilities. The other Lincoln-Mercury design was toned down a bit, but had two interesting possibilities for side detailing, as well as some crisp, low-profile tail fins.
Ford investing $500M in engine plant for 2.7L EcoBoost production
Sun, 30 Mar 2014Ohio is a hot area for Ford at the moment with the announcement just a few weeks ago that production of the next-generation F-650/F-750 medium-duty trucks would move from Mexico to the Ohio Assembly Plant in Avon Lake, Ohio. Now, Ford is investing $500 million to hire 300 workers at its Lima Engine Plant in Lima, Ohio, to add production of the twin-turbo 2.7-liter EcoBoost V6 for the 2015 F-150.
The latest investment will be used to add a new flexible engine assembly system and renovate 700,000 square feet of the plant for machining and assembly areas. The Lima factory already builds Ford's 3.5-liter and 3.7-liter Duratec V6 engines. The plant opened in 1957, and it's on track to build its 40 millionth engine later this year.
Ford claims that the 2.7-liter EcoBoost will offer V8 performance with better efficiency in the F-150. It comes standard with intelligent stop/start that doesn't activate when the truck is towing or in four-wheel drive, and it's made from a combination of compacted graphite iron and aluminum for low weight and high strength. The company says that V6 engines have already proven popular in the F-150 with 57 percent of trucks in 2014 being equipped with either the naturally aspirated 3.7-liter or turbocharged 3.5-liter EcoBoost engines.