2013 Ford Fiesta Se Sedan 4-door 1.6l on 2040-cars

Auto blog

Hot sales have Detroit automakers shortening summer shutdowns

Back in May, there was speculation that the Detroit Three automakers would maintain or perhaps even extend their traditional summer shutdowns, mostly due to a bitingly cold winter that saw below-freezing temperatures infiltrate the southernmost reaches of the US, putting a chill on auto sales. Now, though, the numbers are in, and thanks to some promising sales figures, it looks like some domestic line workers are going to be working clear through July, in some cases.
According to Automotive News, Ford has slashed its traditional two-week hiatus for factory workers in half at four of its plants, while both Chrysler and General Motors will keep factories running nonstop (two plants in Chrysler's case and a third of GM's factories).
This is, as we said, thanks to some positive numbers. Chief among those is the Seasonal Adjusted Annual Rate, which was at an eight-year high of 17 million units. Individual figures were less promising. GM, embroiled in its recall scandal, still saw a one-percent increase while Ford dropped six percent in year-over-year sales. Chrysler was the big winner, though, with a nine-percent jump in June.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.

2015 Ford F-150 shaves 700 pounds, adds 2.7-liter EcoBoost [w/video]

The Ford F-150 is one of the best selling vehicles on the planet. Considering that, one can imagine that when it comes time for a redesign, there are hardly any half measures. For its lucky thirteenth generation, Ford has gone all-in on the single most important vehicle in its portfolio, redesigning it from the ground up.
The big news is the F-150's new, lightweight, Atlas-inspired body. Ninety-three percent of that new body is made from a sort of aluminum alloy not unlike what the US military uses in its M2 Bradley fighting vehicles and Humvees, and it accounts for up to 70 percent of the F-150's 700-pound weight reduction. As a side benefit, the aluminum body should prove more resistant to dents and dings. Built Ford tough, indeed.
If you're wondering where the other 30 percent of that 700-pound weight loss went, 8.5 percent (60 pounds) came from the increased use of high-strength steel (up from 23 percent to 77 percent) in its ladder-box frame. Ford claims this steel is comparable to some of the heavy duty pickups used by its competitors, with a PSI rating of 70,000.