Auto blog

Ford confirms 1.5-liter EcoBoost four-cylinder engine for 2014 Fusion

Earlier this week, reports were swirling 'round the internet about the 2014 Ford Fusion getting a new 1.5-liter three-cylinder EcoBoost engine. That was... half correct. Ford today confirmed that the 2014 Fusion is, in fact, getting a new 1.5-liter EcoBoost mill, but it has four cylinders, not three.
The new 1.5-liter engine will be the fifth EcoBoost powerplant from Ford Motor Company. Initially to be built at the automaker's Craiova, Romania plant, it will also be offered in the Fusion's twin, the Mondeo, in other markets. This engine will debut at the Shanghai Motor Show next month, and the 1.5-liter is of particular importance in the Chinese market - there is significant tax relief in the People's Republic for vehicles powered by engines with a capacity of 1.5 liters or less.
At a media briefing Thursday, Ford declined to divulge exact power or fuel economy numbers, though Joe Bakaj, vice president of powertrain engineering, told Autoblog that power output should be similar to that of the current 1.6-liter inline-four, and that overall efficiency will be "better than the 1.6." Our earlier report stated that the 1.5-liter four will produce 177 horsepower and 177 pound-feet of torque - losses of 1 hp and 7 lb-ft versus the 1.6-liter engine. Ford states that the 1.5-liter four will feature many of the same technologies used on the company's 1.0-liter EcoBoost inline-three, including an integrated exhaust manifold that recaptures much of the engine's heat.

2015 Ford Mustang production to begin on July 14? Not quite, says Ford

Mustang6g.com believes that it has unlocked start date for 2015 Ford Mustang production citing a Ford dealer communiqué. According to the report, job one on the 2015 hardtop will allegedly start in just a few days, on July 14, although units that are known as "OK to Buy" won't enter production until September 9. The cars built between those dates are most likely final pre-production cars for the executive test fleet, and will likely include the cars we'll be driving at the media launch.
Sun worshippers, meanwhile, would seem to have a longer wait. Job one on the droptop supposedly isn't slated to start until September 14, with production models starting on October 27. As is the case with the hardtop, these final pre-pros are for the execs and media to test, while actual dealer orders will come from vehicles made after the October date.
After speaking to Ford, though, we wouldn't put a great deal of stock in those dates as reported. We reached out to Said Deep, Ford's North American Product Communications Manager.

Tanner Foust gets eponymous hotted-up Ford Focus ST from Cobb Tuning

Racer and Top Gear USA host Tanner Foust has partnered up with Cobb Tuning to create a special-edition Ford Focus ST. The limited-edition hatches will come packing a reflashed ECU, special intercooler, tweaked intake and freer-flowing exhaust for up to 20 percent more power than the stock creation. Cobb says that the changes should push the final dyno figure to above 300 horsepower. Buyers can also expect to find special carbon fiber aerodynamic bits on board along with a new grille, graphics and wheels. Cobb hasn't released pricing on this Tanner Foust Edition Ford Focus ST as of yet, but you can bet the whole kit won't be cheap.
Fortunately, the company will sell you bits and pieces from the overall package for your Ford, and word has it engineers are also whipping up a Foust Fiesta ST. Look for Cobb's Focus ST website to go live next month, complete with accurate specs and pricing. Until then, enjoy clicking through the gallery here. You can also check out the full press release below.