This Is A Fully Restored Beautiful Little 1962 Ford Falcon on 2040-cars

Auto blog

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.

NHTSA closes probes on Jeep Grand Cherokee, Ford Freestar and Mercury Monterey

The Detroit News reports the National Highway Traffic Safety Administration has officially closed its investigations into 2012 Jeep Grand Cherokee, 2004-2005 Ford Freestar and Mercury Monterey models. The separate probes found no issues that pose safety concerns. NHTSA began investigating certain Grand Cherokee SUVs over complaints that power steering hoses could detach during operation, thereby increasing the risk of a vehicle fire. Of the 24 reports of failure, none alleged smoke or fire in the engine bay, and Chrysler has since modified the power steering cooler assembly to reduce the likelihood of the failure.
Meanwhile, certain Ford Freestar and Mercury Monterey vehicles garnered a government probe after receiving complaints that the models were equipped with faulty scissor jacks. The agency had received six reports of the jacks failing or causing injuries, including one incident that resulted in a fatality. But NHTSA says the jack failure rate is similar to those found in other vehicles. In those six cases, the government agency found the jacks were being used for something other than changing a tire, and investigators could not determine whether the emergency brake was set or the rear tires were properly chocked.

Shelby GT500 and Roush Stage 3 go head to head at the drag strip

The Ford Mustang is a brilliantly affordable source of horsepower, with a base 300-plus-horsepower version available for well under $30,000. Jumping up to about $35,000 will get you a solid 420 horsepower from a high-revving V8, while those with some extra disposable income can get a pair of 600-plus-horsepower monsters. Both the Roush Stage 3 with its Phase 3 package and Ford's factory Shelby GT500 even crest the 650-horsepower mark, with 675 and 662 ponies, respectively.
Naturally, someone needed to find out which of these hi-po Mustangs was the quickest. And while this video is quite obviously a dealership commercial, at least there's some solid drag racing between two of the most powerful performance machines available for under $100,000.
With two NHRA drag racers at the wheel, the Stage 3 and GT500 go head to head for three races. Scroll down below to see the results in the full video.