1997 Ford Super Duty on 2040-cars

Auto blog

Ford recalling select Taurus, Explorer and Lincoln MKS models over fuel tanks

Ford is recalling certain 2012 Taurus, 2013 Explorer and 2012 Lincoln MKS models over fuel tank concerns. According to the National Highway Traffic Safety Administration, vehicles built between July 19, 2011 and March 15, 2012 may have been built with fuel tanks that have a "marginally sealed seam" on the side. Those seams may not provide the strength necessary to protect the tank from rupture during a collision. They may also leak. The recall covers a total of 3,037 vehicles. NHTSA says that leaked fuel, in the presence of an ignition source, could easily cause a fire.
Dealers will inspect the tanks and replace them as need be free of charge. Owners can expect to be notified once the campaign begins on or around April 22, 2013. You can read the full NHTSA recall notice below for more information.

Ford to pay $17.35 million over Escape recall

Ford had a bit of a recall spree around this time last year, with a pair of issues on the then-new 2013 Escape, followed by a recall of 423,000 2001 to 2004 Escapes because they might accelerate of their own accord. Accordingly, Uncle Sam pasted Ford with a $17.35 million fine because it took too long to inform customers, according to a report from Automotive News.
Ford agreed to settle with the National Highway Traffic Safety Administration, accepting the fine but not admitting fault. The recall, which afflicted Escapes with the 3.0-liter V-6 along with 217,000 Mazda Tributes from 2001 to 2006 and 2008, was due to faulty gas pedals that could stay down after a driver removed their foot.
Ford issued a statement regarding the fine, saying, "We take the safety of our customers seriously and continuously evaluate our processes for improvements. While we are confident in our current processes for quickly identifying and addressing potential vehicle issues, Ford agreed to this settlement to avoid a lengthy dispute with the government."

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).