01 Ford F450 7.3 Power Stroke Turbo Diesel 6spd Manual 10ft Flat Bed Colo Owned on 2040-cars

Auto blog

Ford Fusion production scaled back just 3 months after it was accelerated

Three months after kicking off production of the Ford Fusion at its Flat Rock, MI factory, Ford Motor Company is taking steps to trim output in the face of heavily discounted competition from Toyota and a growing supply of vehicles.
The addition of Fusion production in Flat Rock - which also builds the Mustang - was meant to be what pushed the handsome mid-sizer past its arch-nemesis, the Toyota Camry. An extra facility building Fusions was also meant to curb the growing demand for Ford's highly profitable sedan.
But with word that Flat Rock would take "approximately" one extra week off for the holidays combined with an 88-day supply of Fusions - reportedly due in no small part to what Morgan Stanley analyst Adam Jonas called "aggressive discounting of the Camry" - some analysts are now beginning to wonder if Ford may have overextended itself by adding a second Fusion facility to the mix.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

1947 Chevy rat rod pickup leaves rubber and smoke in its wake

Cool comes in multiple flavors. One one hand, we have the sophisticated attraction of svelte design and the efficient use of power. Of course, on the other hand there is the allure of being the bad boy and going against the grain. That is part of the appeal of rat rods. Ideally, they are built without rules to an owner's specific tastes, and this widened and heavily modified 1947 Chevrolet pickup rod is a perfect example of that spirit.
Coming down the highway with a bent grille, rusted body and pouring smoke, it looks like the pickup from hell. It backs up the looks with some very impressive mechanicals too. Owner Troy Gubser says that the truck packs a Ford Power Stroke diesel with to 42 pounds of boost that runs out of 8-inch exhaust stacks at the back. He claims it managed 505 horsepower and 885 pound-feet of torque on the dyno. To harness all that power, this hot rod has a ZF five-speed manual gearbox with a ceramic clutch and short-throw shifter. Plus, it has cool little features like a doorbell on the tailgate that operates an air horn.
You might not expect a truck like this to actually be useful, but it has a fifth wheel coupling to haul an RV around drag races and car shows. The air suspension also probably keeps the ride fairly comfy when Gubser wants it to be. Scroll down to check out this beastly rat rod pickup and watch it engage in some diesel drag racing. Warning, there is some NSFW language.