2011 Ford F-250 King Ranch 4x4 Diesel Rear Cam 20's 55k Texas Direct Auto on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford Green Zone works magic with GPS to make your drive smarter, cleaner

For the most part, plug-in hybrids rely on the power stored in the battery until that charge is depleted. Unless the switch can be changed manually, it's only then that the cars fire up the internal combustion engine and begin using the fossil fuels on board. This is ideal, of course, when one's drive isn't long enough that the car needs to start sipping gasoline at all. On longer commutes, when it's certain that the route is longer than the car's all-electric range, this isn't necessarily the most efficient use of energy. Ford's Green Zone system is designed to save some of that juice for the parts of the drive that require slower speeds. Ford is working on a smart system, based on Nokia mapping technology, that uses GPS data to use both the electricity and conventional fuel more efficiently. Since battery power is less efficient at highway speeds, Ford's Green Zone system is designed to save some of that juice for the parts of the drive that require slower speeds, rather than just using up all the electrons right at the beginning of the drive. Using a website or the in-car navigation system, the driver can pinpoint the parts of the route, highlighted in green, where using battery power would be more effective, and set the car to automatically switch to electricity for those sections. Depending on the route, the car could automatically switch back and forth between the two power sources multiple times, particularly if the drive is a mix between city and highway driving. Of course, Green Zone will be go beyond that. The program is being developed to take traffic and road grade into account, details that allow the car to be make even smarter choices to improve efficiency. Ford even hopes to have Green Zone learn driver habits, and respond accordingly depending on who is driving the car. The system could control other features as well, such as anticipating corners and shifting the headlights to better illuminate the road ahead. Green Zone could also potentially use information from vehicle-to-vehicle networking to control functions in the car. The Green Zone system still has a few years before it will be ready to be put into production vehicles, but Ford is confident it will make its way onto the road eventually. As with other innovations that improve efficiency and make our vehicles smarter, we can expect to see similar technology from other manufacturers, until it becomes a regular part of driving in the future.

Ford, GM still doing new business with Takata amidst airbag crisis

Lengthy vehicle development times make it difficult for automakers to cut and run from the supplier. You might expect automakers to be fleeing any connection with beleaguered supplier Takata in the wake of the company's exploding airbag inflator crisis. After all, with a Senate hearing, pending lawsuit, plummeting stock value and demand for a national recall, the tier-one supplier isn't at its strongest right now. However, years of cooperation mean that automakers are standing by Takata, and necessity may be playing a role, as well. About 39 percent of Takata's business comes from airbags, and seatbelts make up another significant chunk of the operation too, says Bloomberg. The long-term relationships and lengthy vehicle development times make it difficult for automakers to cut and run from the supplier. "Takata has so much product breadth that I don't really see that they could just disappear," said AutoPacific analyst Dave Sullivan to Bloomberg. For example, Takata helped develop the unique front center airbag with General Motors in models like the Chevrolet Traverse and Buick Enclave. Outside of safety tech, it is also a partner with Ford on the adaptive steering system available on the upcoming 2015 Edge. These long-lasting partnerships make change difficult now that there's a problem. According to Reuters, automakers claim it would take a year or longer to set up with a different supplier for replacement airbag inflators. Switching to a completely different part for the repairs might not be a viable option either, because of the engineering time needed. BMW is taking action, though. According to Reuters, the Bavarian brand is working with the supplier to move inflator production from Monclova, Mexico, to a Takata factory in Freiburg, Germany. The Mexican plant may be the source of some of the faulty parts. News Source: Bloomberg, ReutersImage Credit: Jens Meyer / AP Photo BMW Ford GM Safety Takata airbag recall