Hotrod Truck on 2040-cars

Auto blog

Hurricane Sandy cost automakers 15,000 vehicles, may have ruined up to 200k

Hurricane Sandy was the largest Atlantic storm in US history, and its total economic impact is just now coming into view. According to Automotive News, Toyota, Chrysler, Nissan and Honda are set to scrap around 15,000 new vehicles ruined by the storm. Nissan alone accounts for about 40 percent of those, with 6,000 Nissan and Infiniti models deeded "un-saleable" due to damage. The company saw 56 dealerships shuttered due to the storm, but 51 of those have since reopened.
Toyota, meanwhile, had some 4,000 vehicles at its Newark port facility, and of those, 3,000 may be scrapped. An additional 825 were dealer inventory when they were ruined. Honda and Acura dealers are reportedly sending 3,440 vehicles to the salvage yard. By comparison, Chrysler weathered the storm fairly well with 825 units destroyed, while Hyundai suffered only 400 lost units and Kia scrapped around 200.
As you may recall, Fisker also suffered some losses, and Automotive News reports the manufacturer saw 320 Karma models damaged beyond repair. Ford and General Motors have yet to come up with estimates, and no automaker has commented on the full cost of replacing the vehicles.

2015 Ford F-150 shaves 700 pounds, adds 2.7-liter EcoBoost [w/video]

The Ford F-150 is one of the best selling vehicles on the planet. Considering that, one can imagine that when it comes time for a redesign, there are hardly any half measures. For its lucky thirteenth generation, Ford has gone all-in on the single most important vehicle in its portfolio, redesigning it from the ground up.
The big news is the F-150's new, lightweight, Atlas-inspired body. Ninety-three percent of that new body is made from a sort of aluminum alloy not unlike what the US military uses in its M2 Bradley fighting vehicles and Humvees, and it accounts for up to 70 percent of the F-150's 700-pound weight reduction. As a side benefit, the aluminum body should prove more resistant to dents and dings. Built Ford tough, indeed.
If you're wondering where the other 30 percent of that 700-pound weight loss went, 8.5 percent (60 pounds) came from the increased use of high-strength steel (up from 23 percent to 77 percent) in its ladder-box frame. Ford claims this steel is comparable to some of the heavy duty pickups used by its competitors, with a PSI rating of 70,000.

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.