1973 Ford F-100 Ranger Barn Find 36,921 Original Miles on 2040-cars

Auto blog

Ford Fusion demand outstripping supply

The attractive new 2013 Ford Fusion has done wonders for the brand in the highly competitive midsize sedan segment - the vehicle is up nearly 22 percent compared to last year. But that sales momentum may soon hold steady due to low inventory levels of the new Fusion across the United States.
According to a report in The Detroit News, citing automotive data and Ward's Auto, Ford currently has a 39-day supply of the Fusion. That might sound fine, but a normally healthy average is about a 60-day supply. If Ford were to stop production on the Fusion today, there would only be enough vehicles available to get through another five weeks of sales, according to the News.
Currently, Ford produces the Fusion at its three-shift assembly plant in Hermosillo, Mexico, and will add production at its facility in Flat Rock, MI later this year. A Ford spokesperson told The Detroit News that when Flat Rock production comes online, the automaker will need to rush new stock out to the regions with the most demand for the Fusion. Ford has doubled its coastal retail market share, with huge amounts of growth in areas like Los Angeles, San Francisco and Miami, the News reports.

2015 Ford Mustang production to begin on July 14? Not quite, says Ford

Mustang6g.com believes that it has unlocked start date for 2015 Ford Mustang production citing a Ford dealer communiqué. According to the report, job one on the 2015 hardtop will allegedly start in just a few days, on July 14, although units that are known as "OK to Buy" won't enter production until September 9. The cars built between those dates are most likely final pre-production cars for the executive test fleet, and will likely include the cars we'll be driving at the media launch.
Sun worshippers, meanwhile, would seem to have a longer wait. Job one on the droptop supposedly isn't slated to start until September 14, with production models starting on October 27. As is the case with the hardtop, these final pre-pros are for the execs and media to test, while actual dealer orders will come from vehicles made after the October date.
After speaking to Ford, though, we wouldn't put a great deal of stock in those dates as reported. We reached out to Said Deep, Ford's North American Product Communications Manager.

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.