1962 Ford F100 Pickup Fully Restored on 2040-cars

Auto blog

NHTSA closes probes on Jeep Grand Cherokee, Ford Freestar and Mercury Monterey

The Detroit News reports the National Highway Traffic Safety Administration has officially closed its investigations into 2012 Jeep Grand Cherokee, 2004-2005 Ford Freestar and Mercury Monterey models. The separate probes found no issues that pose safety concerns. NHTSA began investigating certain Grand Cherokee SUVs over complaints that power steering hoses could detach during operation, thereby increasing the risk of a vehicle fire. Of the 24 reports of failure, none alleged smoke or fire in the engine bay, and Chrysler has since modified the power steering cooler assembly to reduce the likelihood of the failure.
Meanwhile, certain Ford Freestar and Mercury Monterey vehicles garnered a government probe after receiving complaints that the models were equipped with faulty scissor jacks. The agency had received six reports of the jacks failing or causing injuries, including one incident that resulted in a fatality. But NHTSA says the jack failure rate is similar to those found in other vehicles. In those six cases, the government agency found the jacks were being used for something other than changing a tire, and investigators could not determine whether the emergency brake was set or the rear tires were properly chocked.

Ford Fusion demand outstripping supply

The attractive new 2013 Ford Fusion has done wonders for the brand in the highly competitive midsize sedan segment - the vehicle is up nearly 22 percent compared to last year. But that sales momentum may soon hold steady due to low inventory levels of the new Fusion across the United States.
According to a report in The Detroit News, citing automotive data and Ward's Auto, Ford currently has a 39-day supply of the Fusion. That might sound fine, but a normally healthy average is about a 60-day supply. If Ford were to stop production on the Fusion today, there would only be enough vehicles available to get through another five weeks of sales, according to the News.
Currently, Ford produces the Fusion at its three-shift assembly plant in Hermosillo, Mexico, and will add production at its facility in Flat Rock, MI later this year. A Ford spokesperson told The Detroit News that when Flat Rock production comes online, the automaker will need to rush new stock out to the regions with the most demand for the Fusion. Ford has doubled its coastal retail market share, with huge amounts of growth in areas like Los Angeles, San Francisco and Miami, the News reports.

Ford F-Series Super Duty prototype reduced to smoldering mess of aluminum and steel [UPDATE]

The most important bit of information you need to know after looking through our high-res gallery of images depicting a prototype 2016 Ford F-Series Super Duty pickup truck burning to the ground is that nobody was hurt. There were two engineers inside the vehicle when it caught fire, and both exited to safety.
That's the good news. The bad news is that the truck, which appears to have been testing in Death Valley, appears to be a total loss, minus, of course, whatever information Ford can glean from the conflagration - particularly tracing it back to its root cause. Besides that, we're also expecting the body of the next Super Duty to be hewn from aluminum, as is the case with its smaller brother, the brand-new F-150. Note the little aluminum droppings littering the roadway as apparent proof of that.
Our spy photographers report that it took just 21 minutes for the F-Series Super Duty to burn completely to the ground. The fire appears to have started in the driver-side front wheel well, spreading to engulf the entire front end in three minutes. We can't confirm the source of the blaze, but we're curious if the car's black vinyl cladding, meant to obscure the secrets within, contributed to the fire.