2006 Ford Explorer Limited on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Junkyard Gem: 1971 Mercury Comet 2-Door Sedan

When Ford introduced the original Maverick for the 1970 model year, Dearborn tradition required that a Mercury-badged version be created. That car ended up being the Comet, built from the 1971 through 1977 model years. Here's one of those first-year Comets in rough but recognizable condition, found in a Denver self-service yard not long ago. The Comet name had spent the 1960s affixed to the flanks of Mercurized Ford Falcons (1960-1965) and Fairlanes (1966-1969). Since the Maverick was the successor of the Falcon — sales of which went into an irrecoverable downward spiral once its sportier Mustang first cousin hit the streets — it made sense to move the Comet name over to the Mercury version. Nearly every American Mercury model ever sold was a U.S.-market Ford model with a different name and some gingerbread slapped on. Notable exceptions to this tradition include the 1999-2002 Mercury Cougar (mechanically based on the Contour but with a unique body) and the 1991-1994 Mercury Capri (an Australian-built mashup of Mazda components borrowed from the Ford Laser). The Comet was by far the cheapest Mercury model available in 1971, though it was considered more prestigious than its Maverick counterpart. The price tag on the '71 Comet two-door sedan started at $2,217 (about $16,505 in 2022 dollars), while the '71 Maverick two-door sedan cost $2,175 ($16,193 today). Meanwhile, AMC would sell you a new Hornet two-door sedan for one dollar less than a Maverick, Chevrolet had the Nova coupe for a dollar more than the Maverick, and Plymouth offered the Valiant Duster for $2,313 ($17,220 now). Toyota had a Maverick competitor as well that year, with the Corona at $2,150 for the sedan and $2,310 for the coupe. Having driven every one of the aforementioned models, I'd take the Duster if I went back in time and had to choose one (as a 1969 Corona owner, I'm not a fan of the 1971 facelift, though the Corona's build quality beats the Duster's). The build sticker on this car tells us that it was built at the Kansas City Assembly Plant (where Transits and F-150s are made today) and sold through the Los Angeles district sales office (there was a DSO in Denver, so it's a near-certainty that this car didn't start out in Colorado). The paint started out as Bright Blue Metallic (it's neither bright nor metallic 51 years down the road) and the interior was done up in Medium Blue Cloth & Vinyl.

Ford recalls 1.3 million Fusions, MKZs: Steering wheels could come off

When driving a car, the steering wheel is only expected to move in a rotational fashion, either clockwise or counter-clockwise. When it moves in some other direction, something is wrong, and when it moves the wrong way enough that it is no longer attached to the steering column, that's a really, really bad thing. And apparently, according to a recall issued by Ford, there are over 1.3 million Ford Fusions and Lincoln MKZs that are at risk of this happening. And at least two accidents and one injury have been attributed to the issue. Ford says the problem is that the steering wheel bolt that keeps the wheel attached to the column might not provide enough torque, resulting in the bolt slowly loosening and working its way off the column. The good news is that the fix is really simple. Ford will install a larger bolt with more threads along with a larger nylon patch to keep it all locked down. The fix is completely free to owners. Cars affected by the recall include 2014 to 2017 Fusions built built at the Flat Rock plant in Michigan between August 6, 2013, and February 29, 2016. Model year 2014-2018 Fusions and MKZs built at the Hermosillo factory in Mexico are also affected. So if you have one of those sedans, please get in touch with your local dealer to have the issue addressed. Related Video: