2014 Ford Expedition El Limited on 2040-cars

Auto blog

Report: GM struggling to market turbo technology

In the automotive realm, marketing can sometimes prove just as important as the actual product. Take, for instance, Ford's well regarded EcoBoost technology, which couples turbocharging with direct injection to produce more horsepower and reduce fuel consumption. Would it surprise you to hear that General Motors has had similar technology on the market for over three years?
It's true. GM's first turbocharged, direct injected powerplants hit the market for the 2007 model. The 2.0-liter Ecotec mills put down an impressive 260 horsepower and a matching 260 pound-feet of torque, and they were lauded by the press in the engine bays of the Pontiac Solstice, Saturn Sky, Chevrolet Cobalt SS and Chevrolet HHR SS. But few people outside a core group of enthusiasts actually remember this fact.
Says Uwe Grebe, executive director of GM's global advanced engineering, "We didn't have a badge and say, 'This is the most important thing we will put on all our brochures.'" Ford, however, did just that, and it's EcoBoost engines are right at the tips of all our tongues when we discuss today's most advanced powerplants. So, how does The General fix its mistake?

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.