2005 Ford Escape Hybrid 4x4 Government Fleet (no Reserve) on 2040-cars

Auto blog

Kawei K1 pickup blatantly copies Ford F-150

The Chinese auto industry used to be looked at as a joke full of products blatantly copied from foreign vehicles. However, companies like Qoros and others show that the country's automakers have taken big steps in terms of original design. It doesn't look like every automaker there is ready to put down the tracing paper yet, though. Case in point: The Kawei K1 pickup pictured above, which is an obvious rip-off of the Ford F-150. In fact, the company isn't even hiding it. Kawei deserves a little credit for its openness. In describing the new model, it says: "No matter the black net grille and the outline of the headlamp, even if the styles of fog lamp and engine cover, it looks the same as Ford Raptor." It also admits that spelling out the model name on the hood is inspired by Land Rover. It's available with either a 2.4-liter, gasoline-fueled four-cylinder producing 141 horsepower and 148 pound-feet of torque (elsewhere it also lists it as having 162 lb-ft) or a 3.2-liter six-cylinder diesel with 106 hp and 181 lb-ft. Regardless of engine, power is sent to the rear wheels through a five-speed manual gearbox. The trucks cost around 100,000 Yuan ($16,033). So at least the K1 is a reasonably priced knockoff. According to Car News China, the K1 is actually selling in small numbers. The company made 10,000 of them last year and even exported some to Africa and the Middle East. Kawei's factory is doubling in capacity this year to build even more. You can read more about the truck on the company's website in some very mangled English. Featured Gallery Kawei K1 Pickup View 11 Photos News Source: Kawei via Car News ChinaImage Credit: Kawei Beijing Motor Show Ford Truck Diesel Vehicles Beijing 2014

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.