2014 Ford Edge Sel on 2040-cars

Auto blog

Detroit 3 and UAW set for showdown over tiered wages

This week, thousands of United Auto Workers will converge on Cobo Center in Detroit for the Special Convention on Collective Bargaining, an every-four-year event that lets members tell UAW leaders what the negotiating priorities should be during contract negotiations. This is where a lot of sand and a lot of lines start coming together in preparation for contract negotiations between the UAW and the Detroit 3 automakers, which will happen later this year. Number one on the UAW agenda is the end of the two-tier wage system created in 2007 to help the automakers get through bankruptcy; veteran workers are paid the Tier 1 rate of around $29.00 per hour, new hires are paid the Tier 2 rate of between $15 and $20 and get about half the benefits of Tier 1. Tier 2 hiring has been an undoubted success for the automakers, allowing them to keep factories in the US and hire more workers. By agreement, it is capped at a certain percentage of each automaker's workforce, and while the union's ultimate position is to get rid of the dual-scale system entirely; one leader said Ford could easily afford the $335 million it would take to convert all its workers to Tier 1 out of its $6.9 billion in 2014 North American profit, and General Motors could do the same out of the $5 billion it is handing to investors through the (admittedly forced) share buyback. Other delegates say that at the very least they'd be happy with enforcement of the current caps in the new contract. The automakers, conversely, would welcome expansion of the Tier 2 ranks. Including benefits, import automakers pay workers "in the high $40 range" per hour, according to an analyst, while Ford and GM pay about $59 in wages and benefits per hour. More Tier 2 workers on the rolls would let those two companies get labor cost parity with the competition. Fiat-Chrysler pays wages closer to the imports because of special exceptions in its UAW contract that allow unlimited Tier 2 hiring; those exceptions will end on September 14 and bring FCA into line with the other domestics, unless the new contract maintains them. FCA CEO Sergio Marchionne is opposed to the two-tier system, having called it "almost offensive." One analyst says the UAW might win a sizable pay raise for Tier 2 and a small increase for Tier 1, but the keystone issue will be how the hiring matrix can help the automakers keep overall wages in line with the imports.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

2015 Gordon McCall's Motorworks Revival

Considered the big kick off of the major festivities surrounding Monterey Car Week, this year's Gordon McCall's Motorworks Revival certainly didn't disappoint. For those unable to make it to the California coast, our own Drew Phillips was on hand to snap some of the beautiful vehicles on display for this gorgeous gallery. Held annually at the Monterey Jet Center, the event is always a feast for the eyes by collecting planes, a gang of exotic supercars, and some the top cars crossing the auction block over the coming days, like a Plymouth Hemi 'Cuda convertible. The Ford GT both new and old was a major attendee at this year's party. Among them, the Petersen Museum brought along an original racecar and a GT40 MKIII to promote an upcoming exhibit. The classics were complimented by the latest version that has continued to keep tongues wagging. The GT wasn't the only classic with a modern update there. Singer used the posh event for the North American debut of its stunning restoration of the Porsche 911 Targa. Shelby American was also at the revival for the public unveiling of the 50th Anniversary Daytona Coupe. On the more modern front, Honda was in attendance with the future NSX and one of the McLaren F1 cars that the company's engine powers. For further proof of the ritzy folks that attend this soiree, Pagani and Koenigsegg both had stands to show off their extremely quick wares.