Wheelchair Accessible, Handicap Lift, Mobility Conversion Self Driver Van Braun on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

BMW V8-powered Ford Model A is the definition of Hot Rod

Today, hotrodding has a pretty staid definition. Take one classic American car, add one classic American V8, sprinkle with tire smoke and you pretty much have every hot rod to roll out of a shop in the last 40 years. Mike Borroughs knows it wasn't always this way. Once upon a time, getting your bucket to go faster meant grabbing whatever parts were lazing about the yard, bolting them together with a bit of ingenuity and laughing your way down the quarter mile. It's in that spirit that Burroughs built his 1928 Ford Model A.
Rather than turn to the tired flathead or the common Chevrolet small block, Burroughs plucked a 4.0-liter V8 from a 1995 BMW 7 Series. With 300 horsepower and 300 pound-feet of torque, the engine has no trouble shuffling the old A around town. He had to build a custom chassis to get everything to cooperate, but the result is a 1,500-pound heathen that looks built to harass dry lake beds. You can check it out in the video below. Be warned, the soundtrack by Hanni el Khatib may not be safe for work - awesomeness of this caliber rarely is.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."