Ford 00 E-150 Full Size Vans E150 94 on 2040-cars

Auto blog

Ford Q3 pretax profits drop to $1.18B

Following positive third quarter financial results recently from General Motors, rival Ford took a tumble in Q3. The automaker posted pre-tax profits of $1.18 billion, compared to about $2.59 billion in Q3 2013, a drop of around 54 percent. Net income also suffered with $835 million made in the quarter, versus $1.272 billion last year, a decline of about 34 percent. The Blue Oval blamed the gloomy figures on three reasons in its release: "lower volume, higher warranty costs and adverse balance sheet exchange effects."
There were problems of one kind or another in practically every region. North America experienced higher warranty costs than expected, partially due to recalls. The sales volume for the quarter was 665,000 units, versus 725,000 in Q3 2013, and pre-tax results amounted to $1.41 billion versus $2.296 billion last year.
South America and Europe both posted worse pre-tax results than last year. On the bright side, European volume was up slightly to 321,000 vehicles, from 303,000 in Q3 2013. The Middle East and Africa also lost $15 million, but that was an improvement compared to the $25 million loss previously experienced in this region.

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.