2012 Ford Econoline 350 Handicap Accessible Wheelchair Van Side Entry Braun Lift on 2040-cars

Auto blog

Junkyard Gem: 1973 Mercury Marquis Brougham 4-Door Pillared Hardtop

Ford's Mercury Division debuted the Marquis in the 1967 model year, as a sporty coupe based on a stretched Ford LTD chassis. When the LTD got an update for 1969, so did the Marquis, and production of that generation of the top-of-the-line Mercury continued through 1978 (the Grand Marquis hit streets the following year). The 1969-1978 Marquis was a big, imposing land yacht, and the Brougham version came absolutely loaded with affordable luxury. Today's Junkyard Gem is a Marquis Brougham from the first year of the Malaise Era, found in a Phoenix self-service car graveyard recently. This car appears to have spent decades sitting outdoors in one of the harshest climates in the country, and so it's in rough shape. The vinyl top received the full thermonuclear treatment and is mostly obliterated by now. The interior got thoroughly cooked as well. Still, its original opulence shines through if you use some imagination. What hurts is that this car was packed with most of the good options, including the mighty 460-cubic-inch (7.5-liter) V8 engine with four-barrel carburetor. The price for the 460 was just $76 in this car, or around $548 in today's money. The base engine was a 429 (7.0-liter). Power numbers were way down for 1973 when compared to a couple of years earlier, partly as the result of tightening emissions standards but mostly due to the switch from gross to net power ratings that began midway during 1971 and was completed by the end of 1972. This engine was rated at 202 horsepower and 330 pound-feet. The only transmission available was a three-speed automatic. We can assume that the original buyer of this car and its single-digit fuel economy had a rough time when the OPEC oil embargo hit in the fall of 1973. Believe it or not, air conditioning was not standard equipment on the '73 Marquis Brougham (you had to move up to a Lincoln for that). This one even has the automatic temperature control feature, adding a total of $508 to the cost of this car (about $3,661 in 2023 dollars). That AM/FM/8-track radio—or, in fact, any radio—was an extra-cost option as well, with a price tag of $363 ($2,616 after inflation). The MSRP for the 1973 Marquis Brougham sedan (known as a "pillared hardtop" thanks to the frameless window glass) was $5,072, which comes to $36,555 in today's dollars. Obviously, its out-the-door cost would have been much higher with all the options.

70% of pickups could use aluminum by 2025

In the next decade, the auto industry will see an explosion in its use of aluminum to cut weight and increase fuel economy, according to a study from market analysts Ducker Worldwide cited by The Detroit News. We are already seeing the lightweight metal show up extensively in luxury models from Europe, but with the impending launch of aluminum-intensive 2015 Ford F-150 (pictured above), North America is using it even more, as well. The report predicts 70 percent of US pickups to have aluminum bodies by 2025.
It won't just be pickups that see the benefit, though. The average amount of aluminum in US vehicles is forecasted by the study to grow from an average of 350 pounds in 2013 to about 550 pounds by 2025. The most common parts to use it will be hoods, doors and - to some extent - roofs, as well.
The massive increase in pickups' aluminum content hardly seems surprising. The F-150 is predicted to use so much that it might cause a short-term shortage, according to one earlier report. At the same time General Motors is heavily rumored to be negotiating with suppliers for the next generation Chevrolet Silverado and GMC Sierra. Ram is the last holdout of the Big Three, but the study predicts that not to last.

Plug In 2014: ALTe ready to join Ford's EQVM to convert, sell F-150 PHEV [w/video]

It's been a while since we've checked in with ALTe and its plans to convert big work vehicles like the Ford F-150 into plug-in hybrids. So, when we saw a demonstration vehicle sitting outside the San Jose Convention Center at the Plug In 2014 Conference last week, we had to get a closer look. When we did, we realized that it's been quite some time since we've been in a Ride & Drive vehicle that was all beat to heck. It's been quite some time since we've been in a Ride & Drive vehicle that was all beat to heck. The reason for the well-worn F-150 with 30,000 miles on it is that ALTe has been showing off its extended-range EV technology to lots of people all around the country, and Kyle Maki has been the man on the scene more often than not. "This one, I've taken all over the country," he told AutoblogGreen. "I've wore out that seat, I think. The only reason this one wasn't driven here was because we were in Charlotte [NC] last week and I didn't want to take a chance and not make it in time for this event." In other words, ALTe is out there, ginning up excitement for the idea of a plug-in hybrid Ford with an electric range of up to 40 miles and which can then continue on gas for another 360 miles at around about 25 miles per gallon. ALTe wants to not only convert new vehicles but it also offers retrofits for fleets that are happy with their current fleet. The company offers converted versions of the Ford E350 and E450 utility vehicles now but the near-mythical F-150 PHEV is still "coming soon." Yes, orders are now being accepted, but you will be forgiven if you think this is all happening on a slow time scale. There are simply a lot of things to do before ALTe can sell the truck. ALTe is currently attempting to join Ford's EQVM program, which is the electric version of the standard Qualified Vehicle Modifiers program. The QVM program requires coachbuilders to "be successfully evaluated by Ford Motor Company on criteria such as engineering, the manufacturing process, quality control, and adherence to Ford and Lincoln Divisions guidelines." Qualified applicants must also meet all applicable Federal Motor Vehicle Safety Standards, conform to Ford/Lincoln conversion guidelines and agree to be inspected annually as well as have a "commitment to continuous improvement." Maki has a simpler explanation. "It basically means you're a preferred supplier, a Tier 1, if you will," he said.