2011 Ford E-350 Xlt 12 Passenger Van - Full Factory Warranty on 2040-cars

Auto blog

Ford calling in 28k Edge crossovers over fuel line leak

A problem with the fuel line on certain examples of the Ford Edge has prompted the National Highway Traffic Safety Administration to issue a recall. The issue revolves around the metal housing on the fuel line pulse damper, which was apparently improperly manufactured in the first place and is prone to crack in certain circumstances, leading to a fuel leak. And as we all know, a fuel leak is not a good thing.
The problem affects model year 2012 and 2013 Edge crossovers equipped with the 2.0-liter engine and manufactured between September 2, 2010 and April 25, 2013 - a total of 27,933 units. Although the Lincoln MKX is closely related to the Edge, since it isn't offered with the same engine (to which the problem is related), the recall does not include the premium-badged version. See the recall notice below for further details.

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).

Ford car-camo artist works his craft on Australia's new Falcon XR8

Ford is among the kings of concealment when it comes to test cars. On one recent Mustang SVT mule, the automaker went to the extreme of putting baffles over the exhausts to hide how many there were. Sounds like a lot of work, right? In a new video, the Blue Oval has decided to take fans behind the scenes to show them what it takes to camouflage a prototype. In this case the subject was the recently unveiled 2014 Falcon XR8 for Australia.
Ford's prototype build coordinator Down Under has the very appropriate name of Neil Trickey, and it's his job to obfuscate the important bits of test cars to keep them out of spy shooters' camera lenses. Trickey calls his job a "dark art," and he shows off some of the tricks of his trade in the video. It turns out that the fabric we often see on mules is a type of lycra, but his team isn't above getting out a can of spray paint to conceal parts, too.
Scroll down to watch a video about a man who you probably wish could be a little worse at his job.