1995 Ford E-350 Wheelchair Bus Braun Millenium Lift on 2040-cars

Auto blog

Ford nets $5.7B in 2012, $1.6B in fourth quarter

Ford brought in $5.7 billion in net income during 2012, which is around $307 million less than one year prior. Even so, the automaker closed out 2012 with the highest pre-tax profit for a single quarter in nearly 10 years, earning $1.7 billion in the fourth quarter thanks largely to a higher-than-average truck mix in the US. That's a jump of $577 million over 2011. Likewise, that translated into fourth quarter income of $1.6 billion. All told, Ford set a full-year pre-tax profit record in 2012. But that doesn't necessarily mean everything is rosy in the land of the Blue Oval.
Like every other manufacturer, 2012 saw Ford get hammered in the European Union, where a deep economic recession continues to drive down consumer confidence. The automaker lost more than $700 million in Europe, and saw full revenue of $26.6 billion in 2012. That's a decline of $7.2 billion compared to last yea. Ford says the market for new vehicles in Europe has contracted to 13.5 million units, the lowest number in 17 years. You can read the full press release below for more information.

A tribute to William Clay Ford

The passing of William Clay Ford has been a big event for the company he spent most of his life helping run. Ford spent 57 years working for his family's company. Considering the Blue Oval has been around for over 100 years, WCF's passing is the end of an era for the Dearborn-based manufacturer.
Ford's YouTube channel has issued a short memorial video highlighting the life of the longest-lived grandson of company founder Henry Ford. It follows William Clay from his time as a boy, showing him alongside his grandfather, through his younger years, and into his twilight, as the patriarch of the Ford family.
Take a look below for this touching memorial video on William Clay Ford.

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).