13 E-150 E150 4.6 V8 Keyless Entry Power Windows We Finance! Msrp $28,565 on 2040-cars

Auto blog

Ford recalls 434k vehicles for several unrelated issues

It seems that the hard winter in much of the country has been as rough on some Fords as it has on many people. The Blue Oval is recalling roughly 434,000 vehicles in two separate recalls, and one of them partially caused by the salt used to melt the snow on roads.
The first recall covers 385,750 2001-2004 Escape models in the Midwest, Northeast and Canada because a subframe could rust and eventually fail. This is partially due to the road salt used in those areas, and about 349,000 of the affected vehicles are in the US. To remedy the problem, dealers are installing a reinforcement cross brace on the frame to strengthen them. There has been one crash caused by the failure but no injuries. According to The Detroit News, this is not the first rust-related recall for Ford. It estimates the company has repaired over two million vehicles since 2010 for problems on vehicles related to the iron oxide, including the rear wheel wells of the Freestar minivan.
The second recall covers 48,950 2013-2014 Ford Fusion, Escape, C-MAX and Lincoln MKZ models because welds in their seatbacks don't meet National Highway Traffic Safety Administration standards. The fault affects the front seats, and the sub-standard welds joining the setback to the recliner could increase the chance on injury. There have been no reported injuries or accidents caused by the problem, but there are 42,972 affected vehicles in the US and 4,744 in Canada.

2015 Ford Mustang production to begin on July 14? Not quite, says Ford

Mustang6g.com believes that it has unlocked start date for 2015 Ford Mustang production citing a Ford dealer communiqué. According to the report, job one on the 2015 hardtop will allegedly start in just a few days, on July 14, although units that are known as "OK to Buy" won't enter production until September 9. The cars built between those dates are most likely final pre-production cars for the executive test fleet, and will likely include the cars we'll be driving at the media launch.
Sun worshippers, meanwhile, would seem to have a longer wait. Job one on the droptop supposedly isn't slated to start until September 14, with production models starting on October 27. As is the case with the hardtop, these final pre-pros are for the execs and media to test, while actual dealer orders will come from vehicles made after the October date.
After speaking to Ford, though, we wouldn't put a great deal of stock in those dates as reported. We reached out to Said Deep, Ford's North American Product Communications Manager.

10 automakers shack up in Detroit hotel to talk Takata airbags

Since Takata has decided not to take the lead concerning potential issues with its airbag inflators, the automakers have. Perhaps that's unsurprising, since it's the automakers, not Takata, that will take a beating on the dealership floor if consumers decide its models are a health hazards. The Detroit News reports that Toyota, Honda, General Motors, Ford, Chrysler, Mazda, BMW, Nissan, Mitsubishi and Subaru met in a hotel conference room near the Detroit Metropolitan Airport last week to sort out a way to understand the technical issues involved. So far, faulty airbag inflators have been ruled the cause of five deaths and 50 injuries around the world, but neither Takata nor investigators understands exactly why the inflators are malfunctioning. The National Highway Traffic Safety Administration recently asked Takata to issue a national recall, Takata declined, citing a minuscule failure rate and the fact that it's still investigating the issue. Toyota and Honda then made an industry-wide appeal for "a coordinated, comprehensive testing program" that would pinpoint the problem inflators and get them replaced, and that's what the Detroit meeting was about. Numerous issues, however, will make this a long row to hoe: simply getting the parts to replace the nearly 20 million inflators in cars recalled around the world so far - even working with other suppliers - will take a years, but more importantly, no one knows if the replacement inflators currently being installed will suffer the same issue. Answers will hopefully come quickly with Takata, the ten automakers and NHTSA all independently investigating the problem.