1990 Ford Bronco Xl Sport Utility 2-door 5.0l on 2040-cars

Auto blog

Alan Mulally talks about why Ford's Falcon had to die

When Ford made the decision to end production of the Falcon sedan and Territory CUV in Australia, it wasn't a popular move Down Under. The large, four-door Falcon had been in production for 50 years, and while Ford has reaffirmed its commitment to the Australian market, it's understandable that some people still aren't all that crazy about the Blue Oval's decision.
Speaking to CEO Alan Mulally after Ford's Go Further event in Sydney, Australian site Go Auto reports that the decision was not one made lightly, and that the automaker is doing everything possible to respect the Falcon and Territory's "stakeholders." It's an interesting piece that shows a softer side of a corporation, while demonstrating that Ford is doing everything in its power to make the end of production as smooth as possible for all parties.
Head over to Go Auto for the full series of remarks from Mulally, and then let us know what you think of Ford's handling of the Falcon and Territory discontinuations, in Comments.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Ford Fusion demand outstripping supply

The attractive new 2013 Ford Fusion has done wonders for the brand in the highly competitive midsize sedan segment - the vehicle is up nearly 22 percent compared to last year. But that sales momentum may soon hold steady due to low inventory levels of the new Fusion across the United States.
According to a report in The Detroit News, citing automotive data and Ward's Auto, Ford currently has a 39-day supply of the Fusion. That might sound fine, but a normally healthy average is about a 60-day supply. If Ford were to stop production on the Fusion today, there would only be enough vehicles available to get through another five weeks of sales, according to the News.
Currently, Ford produces the Fusion at its three-shift assembly plant in Hermosillo, Mexico, and will add production at its facility in Flat Rock, MI later this year. A Ford spokesperson told The Detroit News that when Flat Rock production comes online, the automaker will need to rush new stock out to the regions with the most demand for the Fusion. Ford has doubled its coastal retail market share, with huge amounts of growth in areas like Los Angeles, San Francisco and Miami, the News reports.