2003 Ford Windstar Se Mini Passenger Van 4-door 3.8l on 2040-cars

Auto blog

Can an actual Ford F-150 ride on 4 Power Wheels F-150s?

A lot of kids are rough on their toys, especially when it comes to those made to be used outside, like a four-wheeled kid-size Power Wheels. Whether it's cruising through the sand box, carrying piles of rocks in the driveway or crashing around trees in the backyard, these motorized vehicles often take punishment from the moment the giftwrap comes off. The folks at Fisher-Price decided to give their latest F-150 Power Wheels a true torture test worse than any kid could have ever managed by setting a real 2015 Ford F-150 on top of four of them. Would the little toy trucks explode in a shower of plastic shards in a massive collapse, and if not, could they drive away afterwards? The latest F-150 might be 700 pounds lighter thanks to the switch to aluminum, but it's still a fullsize pickup. According to this clip, the truck weighs in at 4,120 pounds, which puts an average of 1,030 pounds on each of the toys. Check out the video above to see how the stunt goes, and click on the gallery below for some behind-the-scenes looks at the setup.

Watch these Australian Ford and Holden muscle cars duke it out

Australia's Motoring has put together a little video on two of the great performance vehicles available down under - the Holden VF Commodore HSV GTS and the Ford Falcon FPV GT R-Spec. And while both FPV and the Falcon might be on their way out, there's still plenty of time for a little head-to-head comparison between the two.
The cars aren't all that well evenly matched, though. The Ford boasts a 5.0-liter, supercharged V8, which the Aussies measure out at 449 horsepower and 420 pound-feet of torque. The HSV, though, with its Corvette-derived, 6.2-liter, supercharged V8 is just too powerful - 576 hp and 545 lb-ft of torque.
Predictably, it doesn't end too well for the Ford. As the guys from Motoring point out, the new VF Commodore is just too new and too good, with its extra power and its adaptive dampers (GM's excellent MagnaRide). Interestingly, Motoring did point out that the Holden's electric steering is better than the Ford's hydraulic steering, which is a lot like a Porsche purist saying they prefer water-cooled engines to air cooled.

Ford finds flex-fuel engine design plays big role in emissions output

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.