2005 Ford Thunderbird 50th Anniversary 1 Owner!!! on 2040-cars

Auto blog

Ford Focus PHEV on the way?

A refreshed Ford Focus is in the works and that means a few details are leaking out. Spy shots from last month indicated the Focus will have a gaping grille just like its "One Ford" global C-segment comrade, the Fiesta. While Ford is being quiet about it, the Focus could also be getting an "Energi" option, joining the C-Max Energi and Fusion Energi in Ford's plug-in hybrid family. The Focus will likely use technology originated in the C-Max Energi that combines a 2.0-liter gasoline engine with an electric motor capable of a 20-mile range, according to Autoexpress. The pure electric Focus is expected to stay in the lineup despite its slow sales; its price range should be similar to what's on the market now. The third-generation Focus looked good enough to become the top-selling nameplate in the world in 2012. Some exterior changes to look for in the Euro-spec model at the Geneva Motor Show in March include a reshaped hood, front wing endplate and rear bumper. Interior spy shots have hinted at an updated dashboard design and a simplified, less cluttered control panel with updated climate controls. Under the hood, there are quite a few power options rumored to be available - a gasoline EcoBoost with up to 123 horsepower and two turbo-diesel TDCI options, a 1.6-liter or 2.0-liter mills that would produce between 94 hp and 161 hp. Then there are new 1.5-liter diesel and 1.5-liter EcoBoost gasoline variants that meet regulations in China, Brazil and Russia.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford celebrating 80 years of Aussie utes as it prepares to shutter Oz manufacturing

Ford is ending Australian production after 90 years in 2016, and with it may go perhaps the most iconic vehicles in its auto market - the ute. Car-based pickup trucks like the Ford Ranchero and Chevrolet El Camino were always more of a curiosity than a true market force here, but in Australia, they have long proven hugely popular.
As the legend goes, Ford invented the niche after a farmer's wife had asked Ford Australia's managing director for a more utilitarian car. Her request was simple: "My husband and I can't afford a car and a truck but we need a car to go to church on Sunday and a truck to take the pigs to market on Monday. Can you help?"
Ford's design team came up with a two-passenger, enclosed, steel coupe body with glass windows and a steel-paneled, wooden-frame load area in the rear. The sides of the bed were blended into the body to make it look more unified, and to keep costs down, the front end and interior were based on the Ford Model 40 five-window coupe. Power came from a V8 with shifting chores handled by a three-speed manual. Within a year, the new vehicle was ready, and production began in 1934. Lead designer Lewis Bandt christened it the coupe-utility.