2003 Sesvg Used 3l V6 12v Automatic Fwd Sedan Premium on 2040-cars

Auto blog

Ford to auction Mustang Cobra Jet prototype for charity [w/video]

Prototypes developed by major automakers typically remain in said company's custody, but every once in a while, one trickles out into private hands. And that's just what we have here. Ford is donating a one-of-a-kind factory prototype for the 2014 Mustang Cobra Jet that will be auctioned off later this month by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society.
Powered by a 5.0-liter supercharged V8 mated to a T4 competition gearbox, this rare Cobra Jet prototype includes a wheelie bar, chromoly roll cage, Weld wheels, three-link rear suspension, racing brakes, 9-inch rear axle and more. It's painted in a unique satin orange with reflective gray striping scheme, bears the serial number 2014 BJMS CJXX1 and is fully ready for NHRA competition on the drag strip.
To be offered with no reserve on Saturday, September 28, 2013, the Cobra Jet prototype's winning bidder will also receive tutelage at Roy Hill's Drag Racing School in Sophia, NC, along with tours of the Ford Product Development Center, Ford Racing headquarters and Ford Design Studios with Mustang chief engineer Dave Pericak. Scope out the video and details below for what could be the ultimate Mustang experience for a good cause.

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.