2014 Ford Taurus Limited on 2040-cars

Auto blog

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.

NHTSA upgrades Ford floor mat unintended acceleration probe

According to a Bloomberg report, the National Highway Traffic Safety Administration has upgraded an investigation into complaints of unintended acceleration lodged against Ford vehicles. The investigation began in June of 2010 when just three complaints had been received and it only concerned the Ford Fusion and Mercury Milan, but this was at a time when the phrase "unintended acceleration" made grown men go pale. With 49 additional complaints received since then, the investigation has been reclassified as an engineering analysis - the last phase before a recall - and it has been expanded to include the Lincoln MKZ, making for a total of "around 480,000" units affected between the three sedans from the 2008 to 2010 model years.
The ostensible cause is that floor mats are trapping the accelerator pedal, but according to a Ford statement at the time, the entrapment is due to owners placing the optional all-weather floor mats, or aftermarket floor mats, on top of the car's standard floor mats. NHTSA has backed up that assessment, pinning the blame on "unsecured or double stacked floor mats."
On the face of it, it would appear that NHTSA has upgraded the status not because of Ford's error, but owner error, and Ford has stated publicly that it is "disappointed" in NHTSA's move. On top of NHTSA still being skittish after that other unintended acceleration debacle, it could be seen to be taking its time investigating all of the variables: it's reported that Ford changed its accelerator pedal design in 2010, a "heel blocker" in the floorpan has been considered a potential culprit in how the floor mats could be trapping the pedal, some drivers have said the floor mats weren't anywhere near the pedal, and according to a report in the LA Times, in "a letter sent by Ford to NHTSA in August 2010, the automaker said it found three injuries and one fatality that 'may have resulted from the alleged defect.'"