1979 Ford Ranchero on 2040-cars

Auto blog

Ken Block's 1965 Ford Mustang Hoonicorn RTR and CR Supercars Villain are retro done right

Gymkhana king Ken Block has had a pretty simple car history in his trademark videos, starting out with Subaru Impreza rally cars before moving into Ford Focus racers for the past four installments. His next video, though, Gymkhana Seven, kind of goes back in time.
Rather than the cutting-edge rally racers of past videos, Block will pilot a heavily modified 1965 Ford Mustang, called the Hoonicorn. How heavily modified is it? Well, Block's Hooligan Racing Division, ASD Motorsports and Vaughn Gittin Jr.'s RTR, spent two years working on it, ditching the standard engine and rear-wheel-drive layout and replacing it with a 410-cubic-inch Roush Yates V8. Yes, that's a NASCAR engine, and it produces 845 horsepower.
A NASCAR-powered Mustang would be news in itself, but it's the other powertrain changes made by Block and Co. that really makes headlines. Power is channeled through a one-off Sadev transmission and all-wheel-drive system, meaning that Block has basically married a NASCAR stock car with a WRC racer. ASD also developed the customized suspension, tubular chassis and roll cage. The wide Mustang body is the work of RTR and Block's own Hoonigan Racing Division, while the 18-inch fifteen52 wheels are shod in Pirelli Trofeo R tires that use a specialized compound exclusive to Block.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

1969 Ford Talladega GPT Special is a SEMA showstopper

Rad Rides by Troy has unleashed upon the SEMA crowds this custom 1969 Ford Torino Talladega GT Special, and it's a beauty. The car calls to mind the classic Holman Moody stock cars that circled NASCAR tracks in the late 1960's, driven by the likes of Mario Andretti, Dan Gurney and David Pearson, who won the Grand National title in both 1968 and '69 in a Ford Torino.
Even though it has plenty of stock-car influence, there's nothing retro about the car's design or powertrain, other than the fact that the engine is based on a Ford Boss 429 block. Fuel injection, aftermarket aluminum heads and a high-tech custom computer system combine to send 750 reliable ponies to the rear wheels through a Tremec five-speed manual transmission. Brakes measure 14-inches all around, with six-piston Wilwood calipers up front and four-piston units out back.
There's custom bodywork abound, painted in a two-tone Tennessee Whiskey Gold and Daytona Sand finish. Check out all the amazing details in the image gallery below, and scroll down to read all about it in designer Troy Trepanier's own words.